Table of Contents
Advertisement
usrNG
MtcRoPHONE(S)
1.
Plug
the microphones into the MIC jacks.
2. Set
the SELECTOR switch
to
MIC,
and
the
MODE switch
to
STEREO NORM.
3.
Adjust the volume by slowly tuming the VOLUME control
to the right.
The BASS and
TREBLE controls
should
normally
be set
at
FLAT.
NOTES:
o
Use
only
high-impedance,
dynamic
microphones
fitted with
stand
ard pluss (6.4d).
r
Howling may occur
if
the VOLUME control
is
turned
too
high
or
if
the
microphone
is
too
close
to
the
speakers.
o
One
microphone
can
be
used
with
its
plug connected
to either L
or
R
jack, setting the MODE switch at MONO L or MONO
R
position
respectively.
FOWER
AMPLIFIER
USING
A
CARTRIDGE TAPE PLAYER
1.
Set the SELECTOR switch
to
AUX.
2.
Start the cartridge tape
player.
3.
Adjust the volume and tone controls
as
required.
ASSEMBLING
A
MULTI.AMP
SYSTEM
A 2-way
or
3-way
multi-amplifier
system can be assembled by
adding
a
separately available electronic crossover network
(Pioneer
SF-500, SF-700,
for
example) and one or two addi-
tional power amplifiers (Fig.
12).
1.
Remove
the
PRE
OUTiMAIN IN
plugs on the rear
panel
of the
SX-828
(Fig.
13).
2.
Connect
the input
terminals
of
the electronic
crossover
network
to
the
PRE-OUT jacks
of
the
SX-828.
3.
Connect the LOW
range
output terminals of the electronic
crossover
network
to
the MAIN
IN
jacks
of
the SX-828.
4.
Connect the
MID
range
output
terminals
of
the electronic
crossover
network
to
the input
terminals
of
the
power
amplifier
for
mid
range,
and
the HIGH
range
output termi-
nals
to
the
input
terminals of the power amplifier
for
high
range.
NOTE:
A
fine
selection
of
high-performance
electronic
crossover networks,
power
amplifiers and
suitable
multi-amp
speaker systems are available
from
Pioneer.
(LOW-
RANGE}
sx-828
Fig.
12
F
ig.
13
Hide quick links:
Advertisement
Table of Contents
