THERMOBIND TB300 User Manual

USER MANUAL FOR THERMOBIND TB300
①Operating Instructions:
1. Plug the unit directly into an 110-120Volt outlet and turn on the power
switch located at the right rear. The RED Power light will be on during
warm-up. ( about 90 seconds)
2. When the YELLOW "ready" light comes on, the machine is set for
binding.
3. Fill your thermal binding cover with the sheets you wish to bind. Place
the cover into the machine with the spine resting squarely on the
heating plate. The built-in paper clamp will hold the cover upright.
4. Press the "Counter" button once. The GREEN light will then start
blinking.
5. After about 80 seconds, the binding cycle will be completed. A buzzer
will sound and the GREEN light will stop blinking.
6. Before removing the booklet from the machine, push down on the
pages while holding the front and back covers firmly so that you can be
sure that all the pages are making contact with the melted adhesive.
7. Remove the bound book from the machine. Place it in the cooling rack
and leave it for about 5-10 minutes. Do not try to open the book until it
has thoroughly cooled.
8. To continue binding, please repeat steps 2 through 4. The binding time
will be reduced in successive cycles if you insert new folders before the
machine has fully cooled down.
9. Turn the machine off after binding.
Auto Off
1. This machine features an Auto-Off function
2. Once the binding cycle is completed, and the buzzer sounds, the Auto-
Off function is initiated automatically and the machine will begin to cool
down to a lower temperature. If the binding "Counter " button is not
pressed again within ten minutes, the machine will turn off
automatically.
②Safety Instructions

Read this operation manual before using the unit.

Never attempt to open and service the unit. The are NO user
serviceable parts inside the thermal binding machine.

Any repairs must be done by authorized personnel. Unauthorized
servicing of the unit will render the warranty void.

Plug the machine into a grounded socket. It should be easily accessible
and out of the way of walking passages. If it is absolutely necessary to
use an extension cord, it must be a heavy duty grounded appliance
cord.

The heating unit surface will be hot during operation. Children should
not operate the machine without close adult supervision.

This machine is designed and manufactured for indoor use only.

Should smoke or unusual odor be noticed, unplug the unit immediately
and call for service.

Take care to prevent spilling liquid into the machine.

Never put your finger or anything other than the right type of thermal
binding covers, or non-conductive adapter into the machine.