Table of Contents
Advertisement
Section 5: Maintenance & Lubrication
Refer to Figure 5-4:
Remove the cover over the fuse to access the fuse.
23809
20amp Fuse W/Cover Removed
Figure 5-4
Before attempting any diagnosis of electrical system,
use a test light or voltmeter to check battery voltage. If
battery voltage is satisfactory, check cleanliness and
tightness of terminals and ground connections. A
general understanding of electrical servicing and use of
basic test equipment is necessary for troubleshooting
and repair.
Major overhaul or repair of starting motor or alternator
should be performed by trained technicians only.
Hydrostatic Drive System
Refer to Figure 5-5:
!
WARNING
Always wear adequate eye protection when servicing the
hydraulic system.
IMPORTANT: Do not use a high pressure washer
on or around the hydraulic transaxles. Water
intrusion will result and void the warranty.
The Razor is equipped with Hydro-Gear ZT-2800
(Integrated Zero-Turn Transaxle) units. These units are
self contained and maintenance free except for changing
oil and filters. Access the ZT-2800
two bolts at the back of the seat platform and then pivot
the platform up and forward.
NOTE: If the seat is equipped with the optional arm
rest kit, make certain to place the control arms in the
park position and pivot the arm rests upward before
tilting the seat platform.
IMPORTANT: Repairs to an ZT-2800
be performed by trained technicians only.
TM
NOTE: The ZT-2800
bypass valves. For more information refer to "Moving
Mower with Stalled Engine" on page 15.
7/22/10
Table of Contents
Uncovered
20 Amp Fuse
TM
TM
units by removing
TM
unit should
units are equipped with
Z44 & Z52 (S/N 526171 & Above) Accu-Z Razor
Left Expansion
Tank
Right Expansion
Tank
24895
Access to ZT-2800
Figure 5-5
Transaxle Oil and Filter Change
The mower has two independent hydrostatic transaxle
systems. Each system will require separate oil and oil
filter changes. It is best to change oil soon after using the
mower while dirt particles are still suspended in the oil.
See page 43 for transaxle oil specifications.
Initially, change oil and oil filters after the first 25 to 50
hours of operation. Thereafter, change oil and filters
every 200 hours or every year whichever comes first.
Two filters are required with each oil change. They may
be purchased from your nearest Land Pride dealer. Ask
for filter Part No. 831-060C.
IMPORTANT: The transaxles must be purged after
every oil change. See "Transaxle Purging
Procedures" on page 35.
IMPORTANT: Clean debri from around the oil
filter (#5), top port plug (#8) and expansion tank cap
(#11) before draining any oil.
1. Park unit on a flat level surface. Stop engine and
remove ignition key. Make sure blade engagement
switch is in the down (OFF) position. Spread
control levers fully apart.
Refer to Figure 5-6 & Figure 5-7 on page 34:
2. Begin on the left side by placing an oil pan (12" or
more in diameter with approximately 8 qt. capacity)
beneath the transaxle oil filter.
3. Remove screws (#7) and filter guard (#6).
4. Remove hair pin cotter (#4), flat washer (#3) and
clevis pin (#1).
®
Zero Turn Mowers 357-187M
Seat Platform
Back 2-Bolts
TM
Units
33
Hide quick links:
Advertisement
Table of Contents
