Cleanline L Series User Manual

Software Download & Installation
Please follow steps below to download and install monitoring software:
1. Go to the website http://www.powermatic.co.th
2. Click ViewPower software icon and then choose your required OS to
download the software.
3. Follow the on-screen instructions to install the software.
4. When your computer restarts, the monitoring software will appear as an orange
plug icon located in the system tray, near the clock.

Trouble Shooting

Use the table below to solve minor problems.
Problem Probable Cause
No LED display Low battery.
on the front
panel. Battery fault.
The UPS is not turned on.
Alarm continuously The UPS is overload.
sounds when the
mains is normal.
When power fails, The UPS is overload.
backup time is Battery voltage is too low.
shorten.
Battery defect. It might
be due to high temperature
operation environment,
or improper operation to
battery.
The mains is normal Power cord is loose.
but LED is flashing.
TEL: 0-2952-4400
POWERMATIC CO., LTD.
w w w . p o w e r m a t i c . c o . t h
Solution
Charge the UPS at least
6 hours.
Replace the battery with
the same type of battery.
Press the power switch
again to turn on the UPS.
Remove some loads first.
Before reconnecting
equipment, please verify
that the load matches the
UPS capability specified in
the specs.
Remove some critical load.
Charge the UPS at least
6 hours.
Replace the battery with
the same type of battery.
Reconnect the power cord
properly.
User's Manual