Summary of Contents for Scuderia GV2
- Page 3 1.1 - Pull the setting crown at 3 o’clock to the third position and rotate either direction until the corect time is indicated on the silver timekeeping hands. 1.2 - When the time has been set, press crown all the way in again.
- Page 4 2.1 - Pull the setting crown to the third position and rotate counter-clockwise at least two full cycles until the correct day is indicated on the day sub-dial at 6 o’clock. The dial increments one day every 24-hours, so make sure you are aware if the current time is AM or PM.
- Page 5 3.1 - Pull the setting crown to the second position and rotate clockwise until the correct date is indicated on the date wheel. You should make this adjustment in the morning, so the date will not increment at noon. 3.2 - When the correct date is indicated, push the setting crown all the way in again.
- Page 6 4.1 - Press and hold the lower black pusher for two seconds to enter the time setting mode. You will hear a short beep when it is OK to set the red tipped second time zone hand. 4.2 - Press the black pusher again and hold it down continuously until this 24-hour dial indicates the desired time.
- Page 7 5.1 – Pull the setting crown to the second position. 5.2 – Press the top red pusher until the small orange dial at 10 o’clock points to “E” on the Power Reserve indicator. 5.3 – When you are finished, press the setting crown all the way in again. The alarm function is on at this point.
- Page 8 5.4 – Press red pusher until the Power Reserve dial is in the “Off” position. 5.5 – Pull the setting crown to the second position and rotate counter-clockwise until the red-tipped alarm hand is at the desired position. 5.6 – Press the setting crown all the way in again.
- Page 9 5.7 – Press the red pusher again. The small dial at 10 o’clock will first show the status of the power reserve for three seconds and then point to the “On” position to indicate the alarm function is active. 5.8 – The alarm is active until red pusher is pressed again and the power reserve dial returns to the “Off”...
Need help?
Do you have a question about the GV2 and is the answer not in the manual?
Questions and answers
where can I get/order a replacement push button B and its stem/spring?
You can try finding a replacement push button B and its stem/spring for the GV2 Scuderia 9905 by checking online diagrams for part identification, then searching watch parts suppliers or marketplaces that specialize in watch components. You may also consider contacting watch repair forums where members might offer suggestions or parts.
This answer is automatically generated