Desa Wireless Chime User Manual page 2

Wall Anchor
(If Needed)
Note: Most installations will not require you to change any jumpers on your chime and
pushbutton.
The pushbutton and chime communicate by using a code that can be changed by removing
and/or adding jumpers on both the pushbutton and chime. The code is factory set; however,
there are 128 selectable codes that allow you to expand your system and prevent outside
interference. Other wireless products may cause interference and the system may not function
properly. Follow the instructions below for setting a new code.
1. Open the cases and locate the jumpers on both the pushbutton and chime (See illustration
on page 3).
2. The pushbutton and chime both have eight different jumper locations. The jumper posi-
tions 1 through 7 are used for setting the code.
3. To change the code, add and/or remove jumpers as needed. It is recommended to only
change one jumper at a time and then check to see if system is functioning properly. Note:
Jumpers in positions 1 through 7 must be exactly the same for both the pushbutton and
chime for this system to function.
When attaching pushbutton using double sided tape, make sure the
surface of the door jamb or wall is clean.
Mount door chime in a central location so it can be heard throughout
the home.
See actual unit for orientation of base.
Always use mounting wall anchors if not mounting directly into a stud.
Use all 4 mounting holes. Note: 2 mounting holes are located inside
battery compartment. Remove batteries before mounting.
Cover Pins
' D '
P E
T Y
2 0
L R
' D '
P E
T Y
2 0
L R
CODE AND TUNE SETTINGS
Code Settings
Mounting Hole
X
- R
3 5
- 0 0
T R
Mounting Hole
Screw
-2-
Mounting
Orientation
Marking
598-1172-00