Cylligan SY-750S Installation And Operating Instructions Manual

Easy-Change Under-Sink Drinking Water Filter
System Installation and Operating Instructions
Model SY-750S

Specifications

Pressure Range: 30–125 psi (2.1–8.62 bar)
Temperature Range: 40–100°F (4.4–37.7°C)
Rated Service Flow: 0.75 gpm (2.8 Lpm)
Filter Capacity: 2500 gallons (9460 L)
Turbidity: 5 NTU max
Parts Included:
• Filter head with built-in bracket and compression fittings
• 750R filter cartridge
• Screws for mounting bracket
• Water supply adapter
• Lead-free drinking water faucet
• 1/4" plastic tubing
Tools Required
• Phillips Screwdriver
• Utility Knife
(for plastic tubing)
• Towel
• Pencil
Optional Materials
•Center Punch
• / " and / " Drill Bit
1 1
4 2
Precautions
WARNING: Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system.
CAUTION: This filter must be protected from freezing, which can cause cracking
of the filter and water leakage.
CAUTION: Because of the product's limited service life and to prevent costly
repairs or possible water damage, we strongly recommend that the head of the
filter be replaced every ten years. If the head of your filter has been in use for
longer than this period, it should be replaced immediately. Date the top of any
new head to indicate the next recommended replacement date.
CAUTION: Turn off water supply to head without cartridge if it must be left
unattended for an extended period of time.
NOTE:
• For cold water use only.
•Tape Measure
•Adjustable Wrench
•Safety Glasses
•Hand or electric drill
(cordless recommended)
Technical Support: 1-800-645-5426
(M-F 7:30 am - 5:00 pm CST)
• Make certain that installation complies with
all state and local laws and regulations.
• The contaminants or other substances removed or
reduced by the selected
cartridge are not necessarily in your water. Ask your local water municipality
for a copy of their water analysis, or have your private well tested by a
reputable water testing lab.
• After prolonged periods of non-use (such as during a vacation) it is recommended
that the system be flushed thoroughly. Let water run for 2-3 minutes before
using.
• The filter cartridge used with this system has a limited service life. Changes in
taste, odor, color; and/or flow of the water being filtered indicate that the
cartridge should be replaced.
The SY-750S with 750R or 1000R replacement cartridge is Tested and Certified by
NSF International to NSF/ANSI Standard 42 for the aesthetic reduction of Taste
and Odor and Chlorine and Particulate Class I*, Standard 53 for the reduction of
Cysts*, Lead*, Lindane*, Atrazine*, and Turbidity*.
*Applies to 1000R replacement cartridge only.
146153 Rev A 03/04