The Drain Hose At The Siphon Is Blocked; Filter In The Water Supply Blocked - Bosch WAK2020SME Instruction Manual And Installation Instructions

Washing machine
Table of Contents

Advertisement

Switch off the appliance. Disconnect
2.
the mains plug.
Open and remove the service flap.
3.
Take the drain hose out of the
4.
retainer.
Remove the sealing cap, allow the
detergent solution to flow out into a
suitable container.
Replace the sealing cap and place
the drainage hose in the retainer.
Carefully unscrew the pump cover,
5.
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
Place the service flap back on, lock
6.
it into place, and close it.
Cleaning and maintenance
To prevent unused detergent from
Note:
flowing straight into the drain during the
next wash: Pour 1 litre of water into
compartment
and start the
II
programme.
The drain hose at the siphon
is blocked
Switch off the appliance. Disconnect
1.
the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose, residual
water may leak out.
Clean the drainage hose and siphon
3.
connecting piece.
Reattach the drainage hose and
4.
secure the connection using the
hose clamp.
Filter in the water supply
blocked
For this, first reduce the water pressure
in the supply hose:
Turn off the water tap.
1.
Select any programme (except
2.
Rinse//Spin/Drain).
Press
/Reload A. Allow the
3.
Start
programme to run for approximately
40 seconds.
Set the programme selector to
4.
Disconnect the mains plug.
en
[ Empty
.
Off
25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents