Summary of Contents for Rancent Tech DIGITAL VIDEO RECODER
- Page 1 DIGITAL VIDEO RECODER USER’S MANUAL Rancent Technologies Ltd,. 10/F Hong Kong Trade Centre, 161 Des Voeux Road Centrl, Hong Kong Tel: +852 2816 7037 Fax: +852 2855 8158...
-
Page 2: Table Of Contents
User Manual Contents SAFETY INSTRUCTION ................................1 CHAPTER 1: DVR FEATURES..............................2 CHAPTER 2: LAYOUT ................................3 2.1 DVR F ................................3 RONT ANEL 2.1.1 4-CH DVR Front Panel ............................3 2.1.2 8-CH DVR Front Panel ............................4 2.2 R .................................. - Page 3 User Manual 5.5 PTZ C ..................................23 ONTROL 5.6 R ....................................23 ECORD 5.7 S ..................................23 ECORD CHAPTER 6: WEB APPLICATION MANAGER ........................24 6.1 P .......................... 24 INS DOWNLOAD AND INSTALLATION 6.2 W ................................
-
Page 4: Safety Instruction
User Manual Safety Instruction 1. Read Instruction All the safety and operating instruction should be read before the equipment is operated. 2. Power sources This equipment should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power, please consult your equipment dealer. -
Page 5: Chapter 1: Dvr Features
User Manual Chapter 1: DVR Features Function Brief and Description Double video output, with Monitor or VGA virtual output, support Net-viewer and Real-time Monitoring Mobile Live monitor, and also support zoom in/out, auto sequence and PIP display. H.264 video compression format; record quality adjustable, multiple recording Record Function modes (Always, Scheduled, Manual, Alarm, Motion detection and remote record) Record storage... -
Page 6: Chapter 2: Layout
User Manual Chapter 2: Layout 2.1 DVR Front Panel DVR is a short form of Digital Video Recorder. 2.1.1 4-CH DVR Front Panel Key title Item Remark Function & Description or Indicator Power button Power on/off If the “Green” indicator is on the system is getting power Power Indicator normally. -
Page 7: 8-Ch Dvr Front Panel
User Manual 2.1.2 8-CH DVR Front Panel Item Key title or Indicator Remark Function & Description Power button Power on/off If the “Green” indicator is on the system is getting power Power Indicator normally. IR Receiver Receives IR signal from Remote Controller When the “Red”... -
Page 8: Rear Panel
User Manual 2.2 Rear Panel 2.2.1 4-CH DVR Rear Panel 2.2.2 8-CH DVR Rear Panel Item Physical port Connection method Video input Connect CH1-8 (Virtual) video input device（BNC interface） Video output Connect monitor output (BNC interface) Audio I/O 4CH DVR: 4CH audio input and 2CH output; 8CH DVR: 8CH audio input and 1CH output. -
Page 9: Remote Controller
User Manual 2.3 Remote Controller Key title Key function Channel select 1-8; Numeric key 9、0 Numeric key Multiple display mode Menu Enter into Main menu/Exit ▲ Up direction key, Volume adjust ▼ Down direction key, Volume adjust Left/Down direction key,Decrease/increase ◄/ parameter value of control bar Select key/Edit key;Confirm the selected operation. -
Page 10: Chapter 3 Dvr Installation
User Manual Chapter 3 DVR INSTALLATION 3.1 HDD Installation Caution： 1. Please do not Install or take out hard drive when DVR is running! 2. Some model has a HDD drawer. Please use provided key to take out the HDD drawer and put HDD into the drawer correctly. -
Page 11: Chapter 4: Dvr Start Up
User Manual Chapter 4: DVR Start up 4.1 System Initialization After connecting the Power cable of DVR to wall outlet and pressing the Power button on the front panel, you will enter into the system initializing screen shown as Picture 4-1. Picture 4‐1 ... -
Page 12: Main Menu Guide
User Manual 5.2 Main Menu Guide Title Set Camera Color set Display Set Record Resolution Record Record Scheduled Static set DHCP set Network PPPoE set DDNS set Search/Playback File List File Backup Search Main Menu Log Search Log Export Alarm Email Set PTZ set Device Manage... -
Page 13: Main Menu
User Manual 5.3 Main Menu After clicking right button of mouse, pop-up menu appears on the screen. You can click [main menu] option on pop-up menu mode to enter into Main menu interface (Shown as Picture 5-2). In Main Menu mode, you can control device management settings, such as Display, Record, Network, Search, Device and System setting etc. -
Page 14: Network Setup
User Manual [Frame rate] include two options – Fixed and Manual. When set to “Manual” and click [Frame rate setup] option, you may allocate the frame rate for each channel. [Audio] option allows you turn audio on/off. [Mode] allow you select record modes, including Always and Scheduled. - Page 15 User Manual When selecting PPPoE form the Type, user can input user name and password provided by ISP and set Media and Web port (details please refer to the Picture 5-10). You can visit your DVR via public network without port forwarding when network type is set to “PPPoE”...
-
Page 16: Record Search
User Manual above setting. Above steps may differ from the router device depending on the manufacturer. 5.2.4 Record Search Click [Main Menu Record Search] to enter into below window shown as Picture 5-13. Channel: allows you select the channel(s) you desire to search. Time Search: In the Video Search screen, user can search for a specific date and time for a recording and view it in Playback mode. -
Page 17: Playback Player
User Manual Note: Backup file will be saved as H264 format; you can playback the recorded files using the Multimedia Player program that comes with the DVR or through the net-viewer program. Please make sure you have connected backup device, such as USB and DVD, well before backing-up. - Page 18 User Manual 3. Select the playback file you desired from the file shown as Picture 5-21. Picture 5-21 Note: Please select the file with *.264 format or *.nvr. The record file backed-up by U flash disk or removable disk is with *.264 format, and DVD Recorder with *.nvr format. 4.
-
Page 19: Device Management
User Manual [Forward] button: forward playing the record file at X2, X4, X8 and X16 speeds. [Frame by frame]: Play the record file frame by frame. [Snapshot]: click the button to capture the record image and save the image to a specified position. [Add]: click the button to add one record file [Del]: click the button to delete one record file. -
Page 20: Alarm Setup
User Manual USB FORMAT: Use this option to format USB devices. Note: It is an important first step when configuring your DVR to make sure that the hard drive (HDD) options are correctly set. So, it is strongly recommended that you do format the HDD before start the first record. 5.2.6.2 Alarm Setup Click [Main Menu Device Alarm] to enter into the below window shown as Picture 5-26 (a). - Page 21 User Manual EMAIL Setup Click [Email Set] to enter into the interface shown as Picture 5-27. Picture 5-27 On the [EMAIL] screen, when Enabling [Email] option, you can set its parameters shown as Picture 5-28. Picture 5-28 SSL: is a security link transport protocol. You can encrypt your communication info (including your email) using SSL to prevent hackers from monitoring your email or communication info and even your password.
-
Page 22: Ptz Setup
User Manual Picture 5-30 If you can’t receive email alarm information successfully, please check below points: DVR connection is normal or not; The receiver and sender email support SMTP protocols or not; Emails account setting is correct or not; Email alarm parameters configuration is right or not; DVR is on the status of I/O alarm or Motion detection or not. -
Page 23: Motion Detect Setup
User Manual 5.2.6.5 Motion Detect Setup Click [Main Device Motion] to enter into the [Motion Detection] menu shown as Picture 5-33. The [Motion detection] Menu has three sections, including Channel Status, Sensitivity and Motion area. Channel STATUS: This option allow you enable motion detection on any channel. -
Page 24: Video/Audio Setup
User Manual When you set Password Enabled to “ON” (shown as Picture 5-38), you can setup a user password and administrator password respectively. The password supports up to 6 characters. The password defaulted by system is 123456. Picture 5-38 5.2.7.3 Video/Audio Setup Click [Main Menu System Video/Audio] to setup Video and Audio parameters shown as Picture 5-39 (a). -
Page 25: Maintain
User Manual 5.2.7.6 Maintain This option allows you recover the DVR settings to factory default settings, update system software (firmware), and set system auto-maintenance. Click [Main menu System Maintain] to enter into the [System Maintain] menu shown as Picture 5-42(a). Auto Maintain: After enabling [Auto Maintain] function, system will perform regular maintenance as per the schedule you have set. -
Page 26: Record Search
User Manual 5.4 Record search You could enter into [Record Search] menu from Pop-up menu conveniently and quickly and search/playback the record histories. We introduced Record search details previously in section 5.2.4. 5.5 PTZ Control Picture 5-45 Picture 5-46 Picture 5-47 Picture 5-48 Open auto cruise function on PTZ setting menu if you want to setup cruise function (system default: on), and set up cruise channel, cur point and total quantity and stop time etc. -
Page 27: Chapter 6: Web Application Manager
User Manual Chapter Web Application Manager 6.1 Plug-ins download and installation 1. Open your web browser and input the IP address and web port of DVR; 2. If your computer is connected to internet, you will be prompted to download and install “ActiveX Control”; 3. -
Page 28: Web Client Interface
User Manual simultaneously Audio / Video will be automatically connected well (Shown as Picture 6-2(a) and (b). Picture 6-2（a） Picture 6-2（b） 6.3 Web Client Interface 6.3.1 Menu Bar Menu bar include [Live], [Playback], [Remote setting], [Local Setting] and [Logout] option and [Language select] option on the right-up corner. -
Page 29: Remote Setting
User Manual Picture 6-3 Double-click any file listed or highlight any file and click [Play] button to play the selected recording file. Click [Download] button to download and save selected recording file to specified saving path shown as Picture 6-4. Picture 6-4 You can set [Save Path] option on the [Local Setting] menu. -
Page 30: Alarm Parameters
User Manual Click [Copy to] option on the right-bottom corner of the interface to copy all the remote setting to any channel shown as Picture 6-5(c). Enter into [Record Set] option to set record control parameters, including record enabling, audio enabling, Pack time, Record mode and Timer Rec. -
Page 31: Ptz Parameters
User Manual Click [Channel Alarm] option to enable or disenable I/O alarm, video loss and video cover for each channel (shown as Picture 6-9). Picture 6-9 Clicking [Output] option allows you set alarm output parameters, including buzzer time, Post Record time, Alarm out time, and open Pre-record function Picture 6-10 PTZ Parameters... -
Page 32: Network Parameters
User Manual Network Parameters Click [Network Parameters] option to enter into [Network setting] menu, including [Basic character], [PPPoE], [DDNS], [Mobile] and [Email set] (Picture 6-12). Relevant parameters setting please refer to section 5.2.3 – [Network Setting]. Picture 6-12 Picture 6-13 Picture 6-14... -
Page 33: Device Parameters
User Manual Picture 6-15 Picture 6-16 Device Parameters Click [Device Parameters] option to enter into the interface shown as Picture 6-14. Now you can check device info (Picture 6-14), Software version (Picture 6-17) and HDD info (Picture 6-18) etc. Picture 6-17 Picture 6-18... -
Page 34: Device Manage
User Manual Picture 6-19 Device Manage Extend [Device Manage] option to enter into sub menus – System setting, Authority and DST shown as Picture 6-20, Picture 6-21 and Picture 6-22. Picture 6-20 Picture 6-21 Picture 6-22... -
Page 35: Local Setting
User Manual 6.3.1.4 Local setting The option allows you set [Record Save Path], [Frame Save Path] and [File Save Path] shown as Picture 6-23. Picture 6-23 Note：Remote manual recording file will be saved to Record save path. Local recording file will be saved to [File save path]. 6.3.1.5 Logout Click [Logout] option to return back Log-in Interface shown as Picture 6-2. -
Page 36: Chapter 7: Specifications
User Manual Chapter 7: Specifications Model parameter Video System NTSC/PAL(Optional) Video/Audio Video：H.264 Audio：8kHz*16bit ADPCM Compression Format 4-CH BNC input; 8-CH BNC input; Video I/O 2-CH BNC output； 2-CH BNC output； VGA (Optional); VGA(Optional); Audio I/O 4-CH input / 2-CH output 8-CH input / 1-CH output Display Resolution D1：704×576(PAL) 704×480 (NTSC) -
Page 37: Chapter 8: Appendix
List 7-1 User Manual Chapter 8: Appendix 8.1 Record Alarm setting Please refer the below matrix: “⊥” stand for “only alarm but no record”; “AMR” stand for “alarm record”; “NLR” stand for “normal record”; and “NOR” stand for “ no record”. Once alarm is triggered, alarm icon will occur, and when many alarms are triggered, alarm remarks will occur on the screen. -
Page 38: Troubleshooting
User Manual @yeah.net smtp.yeah.net pop.netease.com www.qq.com @qq.com smtp.qq.com pop.qq.com 163.net smtp.163vip.net popx.163vip.net www.sina.com @sina.com.cn smtp.sina.com.cn pop3.sina.com.cn @yahoo.com.cn smtp.mail.yahoo.com.cn pop.mail.yahoo.com.cn www.yahoo.com @yahoo.com smtp.mail.yahoo.com pop.mail.yahoo.com google.com @gmail.com smtp.gmail.com(465/587) pop.gmail.com(995) www.china.com @china.com smtp.china.com pop.china.com www.sohu.com @sohu.com smtp.sohu.com pop.sohu.com Mail.163.com smtp.163.net pop.163.net Mail.163vip.com smtp.163vip.net pop.163vip.net Mail.tom.com @tom.com... -
Page 39: System Configuration
User Manual 10. Q: Why does the Buzzer keep sounding? A: Please check if motion detection is on and the system has detected motion, make sure the HDD is being detected and has sufficient space available; check if video has lost etc. 11. -
Page 40: Accessories
User Manual 8.6 Accessories Power Cord Power Supply User Manual USB Mouse Remote Controller Software CD... - Page 41 The material in this document is the intellectual property of our department . No part of this manual be reproduced, copied, translated, transmitted, or published in any form or by any means without our department prior written permission. Our products are under continual improvement and we reserve the right to make changes without noti ce.
Need help?
Do you have a question about the DIGITAL VIDEO RECODER and is the answer not in the manual?
Questions and answers