Functions Introduction/Usage Preparation; Initial Connection - YATOUR YT-BTA User Manual

4. As for installation on CAN-Bus radios of Peugeot/Citroen, Renault, Ford (new)
and Mazda (new) and Opel, it is required to unplug the radio from the power
before installation. Otherwise, BTA might not work properly or the radio might be
damaged. Regarding Peugeot/Citroen without pre-installed CD Changer, to
enable BTA to work, the CD Changer function must be activated by professional
tools. Please enquire the Peugeot/Citroen dealer on how to activate the CD
Changer function.
5. As per BMW radios with CD Changer, the CD Changer must be completely
disconnected before installation (The 3-pin and the 6-pin connector, both are
located in the trunk, must be disconnected), otherwise BTA will not be
recognized. Besides, if the BMW radios are with DSP, extra DSP kit and specific
BTA would be used.
3- Functions Introduction and Usage Preparation
3.1 Working Modes Instruction
Read over this instruction carefully before using Yatour.
After finishing installation of BTA, press once or twice the CD (or Disc / Mode /
CDC / SOURCE / AUX etc.) button to switch to CD changer working mode (BTA
mode).
Yatour BTA offers 2 types of working modes: HFP/A2DP mode, AUX IN mode.
Under BTA Bluetooth HFP/A2DP working modes, the car stereo must be under
CD1 mode, and you should see CD 1-1 on you car stereo.
When pressing CD02 or Disc+ buttons to switch to CD2 mode, BTA's AUX input
will be valid.
3.2 Connect Bluetooth Mobilephone to BTA

Initial Connection

After BTA being installed, it will automatically direct to the Bluetooth Pairing
Status, this status keeps 3 minutes, during which BTA can be found and connected
by other Bluetooth devices.
1. Turn on Bluetooth of mobile phone, starts to search Bluetooth device (Detail
instruction is showed on mobile phone manual).
2. Turn on the car stereo and switch to BTA playback mode, BTA red LED
indicator will keep lighting, which means BTA starts to work.
3. Search BTA on your mobile phone via Bluetooth. If in 3 minutes BTA is still not
paired successfully, BTA will enter standby status. Under standby status, BTA can
not be found or connected by other Bluetooth devices. Need to hold【 >>】 fast
forward button on car radio for 5 seconds, then BTA will enter pairing status and
keep this status for 3 minutes.
4. Connect with BTA, if pairing code is asked, please enter"0000". Smart phones
usually do not need to enter any pairing code.
—[4]—