Advertisement
Quick Links
®
EntraGuard
Silver Telephone Entry Control
Installation Guide
This installation guide provides basic installation information, drawings, and controller setup instructions to use when
installing the EntraGuard Silver Telephone Entry controller. The EntraGuard Silver controller may be used alone or may
be connected to an access control network using PXL-500 or PXL-250 family controllers. For instructions on how to
install a postal lock, see the EntraGuard Postal Lock Installation Application Note (P/N 01964-001).
NOTE: It is the responsibility of the installation organization to have only technically qualified personnel performing the
installation.
Section 1 - Drawings
Section 2 - RS-232 Serial Port
Section 3 - Setup Controller
Section 4 - Contact Keri Systems
1.0
Drawings
1.1
EntraGuard Silver Enclosure
Figure 1: The EntraGuard Silver Telephone Entry Enclosure
Page 1 of 7
P/N: 01552-001 Rev. B
Advertisement
Summary of Contents for YeriSystems EntraGuard
-
Page 1: Installation Guide
This installation guide provides basic installation information, drawings, and controller setup instructions to use when installing the EntraGuard Silver Telephone Entry controller. The EntraGuard Silver controller may be used alone or may be connected to an access control network using PXL-500 or PXL-250 family controllers. For instructions on how to install a postal lock, see the EntraGuard Postal Lock Installation Application Note (P/N 01964-001). - Page 2 ® EntraGuard Silver Telephone Entry Control Installation Guide Silver Telephone Entry Controller Figure 2: The Silver Telephone Entry Controller NOTE: You must power down the unit before attempting to make or remove any connections. Failure to do so will damage the controller.
- Page 3 ® EntraGuard Silver Telephone Entry Control Installation Guide Board Placement of a PXL Controller Figure 3: Silver Board with Optional PXL-5xx Board Placement NOTE: For information on the optional PXL-500/PXL-510 board, see the PXL-500/PXL-510 Quick Start Guide (P/N 01918-001). For information on the optional PXL-500G-1 board and gate control, see the PXL-500G-1 Quick Start Guide (P/N 01532-001).
-
Page 4: Rs-232 Serial Port
EntraGuard Silver Telephone Entry Control Installation Guide RS-232 Serial Port Using the RS-232 serial port for communication between the EntraGuard unit and the host computer may be done one of two ways: • by direct connect (maximum of 50 feet) •... -
Page 5: Setup Controller
The address range is from 1 to 128. The Master Controller must be set to address 1. Other slave EntraGuard/PXL controllers may be assigned any number from 2 to 128. If the network is made up of PXL-250s, the EntraGuard Silver must be set as the Master. -
Page 6: Diagnostics And Troubleshooting
Once the memory has been cleared, the unit is ready to be configured. The LCD will display a message that the unit has not been initialized. This display will rotate with the EntraGuard Default display until a Total Update from Doors has been performed on the unit. - Page 7 ® EntraGuard Silver Telephone Entry Control Installation Guide Contact Keri Systems Keri USA Keri UK, Ireland, Europe 2305 Bering Drive Unit 17 San Jose, CA 95131 Park Farm Industrial Estate Ermine Street Buntingford Herts SG9 9AZ UK Telephone: (800) 260-5265...