Yamaha YDRA Owner's/Operator's Manual page 39

JC2
MAINTENANCE
Transaxle Oil
To check transaxle oil level:
1. Place the golf car on a flat, level
surface.
2. Remove seven plastic rivets 1
and two bolts 2, and remove
the bag holder insert 3.
3. Place an oil pan under the
transaxle case.
4. Clean area around servicing plug
4.
5. Using an 8 mm hex wrench,
Y-1994
remove transaxle oil servicing
plug located on the rear of the
transaxle case.
6. Transaxle oil should be at the
top of the oil servicing hole or
just beginning to run out of hole.
NOTICE
Do not allow foreign material to
enter transaxle. Serious transaxle
damage can result.
Y-1214
7. If needed, add Yamalube
Friction Modified Shaft Drive
Gear Oil until it is at the top of
the plug hole or just beginning
to run out of servicing hole.
TIP
The golf car is equipped with an
internal wet brake. Use of oil other
than Yamalube Friction Modified
Shaft Drive Gear Oil will cause
brake noise.
8. Install the transaxle servicing
plug and tighten to 14-19 Nm,
1.4-1.9 m•kg (120-168 in•lbs).
1
2
3
4
5
6
7
8
9
10
11
8-10