WARNING & SAFETY INSTRUCTIONS Before you begin the installation of the multi-purpose water filter, we advise you read and carefully follow the instructions contained in this manual. It contains important information about safety, installation, use and maintenance of the product. The actual system that you have received, may differ from the pictures/illustrations/descriptions in these Instructions.
OPERATING CONDITIONS & REQUIREMENTS APPLICATION LIMITATIONS: pH: 5-10 maximum contaminant content: Hardness 75 °f / 42 °d Iron (Fe 15 mg/L Manganese (Mn 3 mg/L Oxidizability (O 4 mg/L Ammonia (NH 4 mg/L OPERATING PRESSURE: min. 1,4 / max. 8,3 bar ...
Page 5
INSTALLATION CONTENT CHECK Actual parts that you have received, may differ from the pictures/illustrations in these Instructions! For ease of transportation and installation, the filter media is NOT loaded in the pressure tank, but delivered in separate bags of 12 or 25 ltr; it must be loaded on-site, after positioning of the pressure tank.
ASSEMBLY INLET & OUTLET DRAIN Check the water pressure at the place of installation of We recommend the use of a stand pipe with air trap. the multi-purpose water filter; it should never exceed 8,3 To prevent backflow from the sewerage system into the bar.
START-UP PRESSURIZING 1. Put the bypass system in 'bypass' position. 2. Make sure the electronic controller of the multi-purpose water filter is in service mode. 3. Open the mains water supply. 4. Open a cold treated water faucet nearby the multi- purpose water filter and let the water run for a few minutes until all air is purged and all foreign material that may have resulted from the installation is washed...
ELECTRONIC CONTROL PANEL Picture 6 REGENERATION MODE In regeneration mode the display shows the total remaining symbol button function regeneration time and remaining cycle time: to advance to the next SCROLL parameter Rgn:123 CycY:456 to increase the value of the parameter The control valve can be reset to service mode at any time to decrease the value of the...
Page 9
ELECTRONIC CONTROL PANEL PROGRAMMING INSTRUCTIONS - INSTALLER Before entering the programming mode, make sure that the control valve is in the service mode. 1. Press the scroll button; the display will show: Language:English Press the up or down button to set the ...
MAINTENANCE ROUTINE CHECKS WATER CONDITIONER SALT This multi-purpose water filter needs 'brine' for its periodic Regularly the user should perform a basic check to verify if regenerations. This brine solution is made from water, that the multi-purpose water filter is functioning correctly, on the is automatically dosed in the brine tank by the control valve, basis of the following control points: and water conditioner salt.
COMPOSITION OVERVIEW Media Control valve, incl. EuroT transformer, Pressure tank, Brine tank, incl. platform, Model Filter media volume 1” male BSP connections incl. distributor assy brine valve assy (12 kg bag) (25 kg bag) model model model 35690 2400VS/J4JB 10x35 125 ltr 35691 2400VS/J1JB...
Page 12
AQUION, INC. Lammerdries-Oost 30c B-2250 Olen Belgium +32 (0) 14-28.51.71 +32 (0) 14-28.51.70 RPR/RPM Turnhout BWT/TVA/VAT BE 0882.738.206 infobelgium@eriewatertreatment.com www.eriewatertreatment.com...
Need help?
Do you have a question about the Simplex Eco and is the answer not in the manual?
Questions and answers