CDI FLEXIBLE FURLER 2 Installation & Operating Instructions Manual page 10

g
11. Slide the furling drum over the luff with the sail feed slot on
the same side as the tack anchor shackle (see drawing
above). You may knock the thrust washer (part "M" on
page 2) out of place doing this. You can push the washer
up into the cavity of the furling drum again. The washer is
designed to ride between the furling drum and the bearing.
12. Screw the T-Bolt
body and adjust until the overall length is
correct. BE SURE TO REPLACE THE
COTTER
TURNBUCKLE.
INSTALL THE LUFF SUPPORT PIN
when you lower the furling drum.
13. Pass the furling line through the
hole in the side of the cup, then up
through the hole in the top of the
furling drum
overhand knot to prevent it from
escaping.
14. Step the mast (if unstepped). Attach the forestay to the
chainplate. Tension rig using backstay turnbuckle or upper
into the turnbuckle
PINS IN
Also, remember
flange. Tie
(8)
YOUR
to
an