Advertisement
1. The battery should be put on the place where is unavailable for children, supposing it is
swallowed by children by mistaken, consult the doctor immediately.
2. Wipe the battery with dry cloth to keep good connection
3. Insert the battery with the right direction
4. Do not hold the battery with mental pincers, or it may cause short circuit
(6) Installation of battery
1. Press the lock and pull out battery box
2. Insert the new battery into the box with positive electrode facing above
3. Install the box at the initial place
6. Basic operation
(1) PC connection
1) Make sure the resolution of PC screen is 800×600. If PC screen resolution is bigger
than 800×600, the touchscreen monitor can not show the picture.
2) Shut down the PC and touchscreen monitor.
3) Connect the VGA cable between PC and the set.
4) Connect the USB cable between PC and the set.
5) Power on the PC and then the set.
6) Install the Touch Driver software into PC. Please refer to the
in the CD. The Touch panel driver supports operation
of Touch driver
systems including Microsoft Windows 95 / 98 / ME / NT4 / 2000 / XP / Vista / 7,
Windows CE 2.12 / 3.0 / .NET, Linux, iMac and DOS.
7) To finish the 4 point Calibration(correct 4 point locations on screen, 4 pts Cal).
Please refer to the
8) The monitor supports static touch, such as finger-touch.
(2) AV connection
1)
Connect the AV cable, the RCA terminal connect AV IN port on the set, the other
Installation manual of Touch driver
- 6 -
8'' Touchscreen Monitor Manual
Installation manual
in the CD.
Advertisement
