D-Link DSL-2640U User Manual page 34

DSL-2640U Wireless N 150 ADSL2+ Modem Router
User Manual
Click the Reboot line if you have already saved the router's settings.
Click the Save&Reboot line to save new settings and immediately reboot the router.
Click the Save line to save new settings to the non-volatile memory and continue configuring the
device. Also you can save the device's parameters via the Save button on the System /
Configuration page.
Click the Backup line and follow the dialog box appeared to save the configuration (all settings of
the router) to your PC. Also you can save the router's configuration to your PC via the Backup
button on the System / Configuration page.
Click the Factory line to restore the factory default settings. Also you can restore the factory
defaults via the Factory button on the System / Configuration page.
Also you can restore the factory default settings via the hardware RESET button located on the
back panel of the router.
device turned on), push, and hold for 5 seconds. Release the button and wait until the router is
rebooted (about a minute).
default IP address, username and password.
When you have configured all needed settings, click the Logout line.
Figure 23. The top-page menu.
Use a small paperclip to activate the button; insert it into the hole (with the
Now you can access the web-based interface of the router using the
Page 34 of 149
Installation and Connection