Basic Operations; Turn On Stb; Power; Vol - Allied Telesis Receiver User Manual

2. Basic Operations

2.1 Turn on STB

First, press the [Device's Main Power] to turn on the unit. When the STB is first used, there will play the first channel from
the default Channel List. If the STB is not first used, STB will play the same channel as last time before turning off.

2.2 Power

1. Press [Power] Key can enter the Standby state.
2. In Standby state, press [Power] Key again can call back the unit and go on play the previous channel.
3. User can also disconnect the device's main power to end the Standby state
2.3 CH
In full screen, press [CH
2.4 VOL⊳ ⊳ ⊳ ⊳
⊳
In full screen, press [VOL

2.5 Channel Number

In full screen, use number key and press [OK] on the Remote Control Unit to change channel.

2.6 Mute

1. Press [Mute] key to mute the sound and the screen will show up mute OSD.
2. Press [Mute] again to restore sound.

2.7 Pause

1. In playing mode, press [Pause] key, the picture will be paused, but the sound of the channel will still continues.
2. Press [PAUSE] key again, the screen's picture will skip over to the current playing picture, and the sound of the
channel will correspond playing.

2.8 Recall

Press [Recall] key will directly switch to the previous channel that you played before current channel.

2.9 FAV

1. In TV channel list press [FAV]. In the window of "Favorite", you can move highlight by press [Channel Up/Channel
Down] key and press [OK] key to select favorite group. To create a Favorite please press [EDIT] key.
], to change channel
], to adjust volume.
5