Table of Contents
Advertisement
Chapter 5 - Power Supply Block Removal
Squeeze Tabs
Release
Cables
Dismount
Lamp Jack
Detector
Screw
Switch
Slide
Jack out
Power Supply Block (Only) Removal
Disconnect
Cables
Cable Guide
11
1
Use the following procedures to
remove the Power Supply Block
only without any other chassis
disassembly.
Disconnect the power and sensor
cables.
Release cables from 2 holders.
Squeeze the 2 upper white tabs
and dismount the Power Supply
Block.
2
Lay the Power Supply Block face
down to the side of the unit .
Remove 1 screw securing the
cable guide.
Remove 1 screw to dismount the
Lamp plug.
CAUTION:
damage the Lamp plug detector
switch when removing and
installing the Power Supply
Block.
Screw
Be careful not to
Hide quick links:
Advertisement
Table of Contents
