Empty The Collection Tank; Fill The Tank; Carpet Cleaning - Bissell QUICKwash DELUXE User Manual

O
perations
Before you clean continued
4. Pretreating (optional) Pretreat stubborn
stains and highly soiled carpet in hallways
and other high-traffic areas.
4a. Generously spray BISSELL Stain Pretreat
evenly over soiled area.
Caution: DO nOT OVEr WET CarPET
4b. Wait 3-5 minutes before deep cleaning.

Fill the tank

1. Remove the solution tank by lifting it straight
up, then away from the lower body.
2. Unscrew the black cap at the bottom of
the solution tank.
3. Fill with hand hot (60°C/140°F MAX)
tap water to the WATER line. Fill the rest
of the tank with BISSELL 2X Formula to
the FORMULA line. Replace and tighten
the black cap. note: do not boil or
microwave water as it can damage
the solution tank.
4. Place solution tank on lower body.

Carpet cleaning

1. Set ReadyTools dial to "FLOOR CLEANING".
2. Plug into proper outlet.
3. Turn the power switch to the ON (I)
position (located on the back of unit)
4. With foot, press the red recline lever
(located on the back of unit).
5. Cleaning Strokes. While pressing the
spray trigger, make one slow forward wet
pass and another one back. Caution: Do
not overwet.
6. Release the spray trigger and make one
slow forward and backward pass over the
same area.
7. Repeat steps 5 and 6 until solution being
pulled up appears clean.
8. Empty the collection tank when dirty water
reaches the full line, or when the solution
tank is empty.

Empty the collection tank

1. Turn power switch OFF (O) and unplug
power cord from outlet.
2. Remove the collection tank from base of unit.
w w w . b i s s e l l . c o m
1.
3.
1.
Recline
Lever
2.
4.
3. & 4. Power
7