Advertisement
6
Device Operation
3.
Insert the USB Standard-A plug
on the other end of the charging
cable into the appropriate USB
port located on the Portable
Power Pack.
4.
To begin the charging process,
press and hold the Power Switch
on the Portable Power Pack until
the battery power indicator lights
turn on. You may charge mobile
devices while the Portable Power
Pack itself is being charged.
If your device requires a different connector
than what is included with the Portable
Power Pack, you can use your device's USB
charging cable or any other appropriate
charging cable, as long as it terminates
in the USB Standard-A male connector
required in order to plug into the Portable
Power Pack.
NOTE: While five separate mobile
devices can be simultaneously
attached to the Portable Power
Pack, they may not total more
than 2.5 amps, and their individual
voltage requirement must be 5
volts. If an overload causes the
device to stop operating, turn off
the battery and wait five minutes
before using it again.
Battery Power indicator Feature
The battery power indicator lights display
the amount of power remaining in the
Portable Power Pack. When all the battery
indicator lights are lit, the Portable Power
Pack has a full charge and is ready for use.
If only one battery indicator light is lit,
battery power is low to minimal and we
recommend recharging the Portable Power
Pack at this point.
When the battery indicator lights do not
turn on, this means that your Portable
Power Pack is out of power and you need
to recharge it.
To turn on the battery indicator lights, press
and hold the power button. The battery
indicator lights will remain lit until you
press and hold the power button again to
turn them off
Advertisement
