Operation; Operating Instructions - Dannyco BabylissRRO BAB821C Operating Instructions Manual

OperatiOn

This professional mini clipper/trimmer is designed for human use only. This appliance
is used on Alternating Current 120V AC (60 hertz) only. This appliance has a polarized
plug (one prong is wider than the other). As a safety feature, this plug will fit in the
outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the proper outlet. Do not attempt
to defeat this safety feature.
BAB500 Detachable
Wide Tooth Cutting Blade
BAB501 Detachable
Fine Tooth Cutting Blade
I-ON / O-OFF
Switch
Blade Guard
10-Foot
Cleaning Brush
Professional Cord
BAB821C IB-11_630A.indd 5-6
Comb Attachment Comb Attachment
# T2 – 1/4" (6 mm)
# T1 – 1/8" (3 mm)
Comb Attachment
Comb Attachment
# T3 – 3/8" (10 mm) # T4 – 1/2" (13 mm)
Lubricating Oil

Operating instructiOns

HOW tO use cOMB attacHMents
1. To use the comb attachments, always turn the appliance to "O-OFF"
position.
2. Slide the comb attachment onto the front of the clipper/trimmer blade
and snap over the back of the blade.
3. To remove, push up the comb attachment at the back of the blade and
remove the comb.
4. Four comb attachments are available: 1/8" (3 mm), 1/4" (6 mm), 3/8" (10 mm) and
1/2" (13 mm).
Maintenance OF tHe BLaDes
Always apply BabylissPro lubricating oil to the appliance before, during
and after each use. This will ensure maximum cutting performance. Hold
the appliance away from your body in a downward position and apply a
drop of oil on the front and sides of the cutter blades. Wipe excess oil off
with a soft dry cloth.
LuBricating tHe BLaDes
You should lubricate the blades with the BabylissPro lubricating oil provided in your
kit. Turn the appliance to the "I-ON" position and hold it so the blades are pointed
downward. Spread one drop of oil across the blades, then turn the appliance to the"O-
OFF" position and wipe away the excess oil with a soft cloth. After cutting wet hair, clean
the blades and apply a small drop of BabylissPro lubricating oil.
Be careful not to use too much oil and don't oil your clipper/trimmer more than
necessary, as this could damage the motor (never attempt to oil the motor bearing, as
it is permanently lubricated). After oiling the blades, return the appliance to the storage
base. Keep oil out of reach of children.
1/28/15 2:25 PM