Microsport Snowsport Speedometer User Manual

Snowsport Speedometer
User Manual
1. Quick Start Guide
READ THIS FIRST
If at any point in these instructions you
have questions, please call +49 (0)89
30725599 or write an e-mail to
service@microsport.de.
Display:
a. To begin, reset your receiver/watch
by pressing all four outer buttons un-
til the screen goes blank.
b. In Time Mode T, press SET button -
upper left.
c. To change a value, press + button
(upper left) and - button (lower right).
d. Press START/STOP button (upper
right) to save the changes and con-
tinue to the next option- 12/24hr
time, time, date, etc.
e. You can always exit the Setup by
pressing MODE
Snowsport Speedometer
Table of Contents:
1. Quick Start Guide
2. Wrist Strap Installation/Removal
3. Setting the Time
4. Time Mode T
5. Speed Mode S
6. Distance Mode D
7. Heart Rate Mode ♥
8. Memory Mode M
9. Calibration Methods
10. Changing the Batteries
11. Trouble Shooting
12. Remarks
Reading the Heart Rate (for optional
heart rate monitor only)
a. Fit the heart rate strap on your chest
with the logo right side up. Wet the
flexible rubber bands
b. Toggle to the heart rate mode ♥
c. Press START/STOP to activate the
transmission
d. Your heart rate will display after
approx. 30 seconds.
Speed and Distance:
a. The button of the Speed-Module
toggles the unit on/off. Press and
holf the button on the Speed-Module
until the red light flashes.
b. Press MODE (lower left on the
watch) and scroll to the S Speed or
D Distance setting.
c. Press START/STOP (upper right) to
begin data collection- as indicated by
the Symbol below the status bar.
Snowsport Speedometer
d. If the speed module could connet to
the display all data and functions are
displayed.
nCon:
This means the receiver is not able to
establish a wireless connection with the
accelerometer module. To correct this:
a. Make sure the Speed-Module is
switched on.
b. Press all four buttons until the screen
goes black and an r appears fol-
lowed by a number. Press
START/STOP; this clears all mem-
ory and time.
c. Change the battery in the acceler-
ometer module and the display. See
section 11.
Getting Started:
Your receiver/watch has a user friendly
menu system. The lower left button
toggles through the MODES, and the
lower right button toggles through the
OPTIONS within each MODE. The dif-
ferent Modes are:
T TIME
S SPEED
D DISTANCE
♥ HEART RATE
M MEMORY
Locate the lower left button and toggle
through the five modes. The OPTIONS
within each MODE are listed below.
When in a particular mode, press the
OPTION/- button to view the various
options. Press MODE to return to the
main view at any time. The functions are
divided into the different main modes as
follows:
T: Time/date, Alarm 1, Alarm 2, Count-
down Timer, Stopwatch, Stopwatch
nd
History, 2 Time Zone
S: Actual-, Average-, Maximum Speed,
Actual-, Average Pace