Installation; Step 1 Insert/Remove Sd Card; Step 2 Bulb Installation; Step 3 Install Back Up Batteries - Smartguard E300CA-1 User Manual

Installation

Step 1
Insert/remove SD card
Unscrew the cover using provided Allen key (FIG. 1a)
Insert provided 2GB SD card or SD card with memory up to 32GB by your choice
into the card slot (FIG. 1b).
Refit the cover, and fasten the screw clockwise (FIG. 1c).
1
2
SCREW HEAD DIMENSION
UNIT:MM
FIG. 1a
Note: If SD card is not inserted properly or not found, SmartGuard will beep 10
seconds once an hour as indication after powering up.
CAUTION:
For security reason, please do not remove the SD card frequently unless an
irregular condition has occurred (e.g. detection of an intruder or breaking attempts).
To view video, please refer to "Viewing Video" at p12.
Step 2
Bulb Installation
Disconnect the power cord or wall switch
Remove floodlight cover by unscrewing the screw at the
bottom edge of the front surround (FIG. 2a) using Phillips
head screw driver.
Take off the front surround, install a
150/300 watts bulb (please refer to
FIG. 2a
Specification on p.13 for correct halogen
bulb for E150CA-1/E300CA-1).
Rotate halogen bulb to assure proper seating.
Refit the front surround in place and fasten the screw (FIG. 2b).
2
FIG. 1b FIG. 1c
4
CAUTION:
(1) Always handle quartz halogen bulb with a soft cloth. Do not touch the bulb with
your bare hand as it will shorten the bulb life.
(2) Do not touch the light while it is in use or still hot. Cool off (about 5 minutes)
before touching it.
Step 3
Install Back Up Batteries
Unscrew and remove the screw of Battery
Cover.
Press and release the cover of battery
compartment
Insert 4 AA size 1.5V alkaline batteries to
the battery spring and make sure polarity (-
+) is aligned correctly.
1
Refit the battery cover.
Note: The batteries power supports most
functions of SmartGuard except lighting.
Step 4
Local Time Setting
The SmartGuard has a LCD panel with three control knobs: Set, Up and Down.
Once SmartGuard is powered up, it enters PIR warm up time. After 3 seconds, the
unit enters standby mode. It implies the unit is ready for function setting.

Standby Mode

FIG. 2b
Warm Up
5