Daylight Saving Time; Line Input; Dimmer Function - Hyundai H-1542 Instruction Manual

battery back-up system is only meant to be used
from short temporary power failures. For longer
durations the battery may become exhausted or
there may be some deviation in accuracy.
• When the battery is exhausted, it should
be removed from the set to prevent leakage.
If you do not wish to take advantage of the
battery back-up system, your set will work
normally without a battery. However, if
disconnected from the mains, the clock figures
will flash when the mains are reconnected and
you must re-set the clock.
AС operation
• The appliance is for household use only.
• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds the mains voltage in your home.
• Insert the plug into the power supply.
• The set is now working as electronic clock.
General operations
Setting the clock and calendar
• Press and hold MODE button. Press it
repeatedly to cycle through time and calendar
settings in following order: Year => Month =>
Day => 12/24H mode => Current hours =>
Current minutes. The selected setting will blink.
• Press repeatedly TEMP/
press and hold it to decrease the setting; press
repeatedly Y-M-D/ button or press and hold
it to increase the setting.
• In normal mode, press repeatedly Y-M-D/
button to switch the display between
current time, year and month and day. Each
indication will be on for 5 seconds, the the
display returns to initial mode.

Dimmer function

To adjust the brightness of the display, slide
the display dimmer switch to HIGH or LOW
position.
Reset
To reset all settings of the unit to default
settings, press the RESET hole with a pointed
object (e.g., a ballpoint pen). This measure is
needed when you changed the batteries in the
unit or if the unit does not function correctly.

Daylight saving time

Press and hold Y-M-D/
switch on or off the DST (Daylight Saving
Time) mode. This enables to observe 1-hour
difference between summer and winter time.
Thermometer
Press TEMP/
temperature. The temerature indicatoin will
be on for 5 seconds, the the display returns to
initial mode. Press and hold TEMP/
to switch between Celsius and Fahrenheit
temperature modes.

Line input

• You can connect the audio output of an
external device to this unit, to listen to the
sound of that device through the amplifier of
this unit.
• To connect an external audio device (eg.
MP3 player), please use a standard stereo
cable (not included) with 3.5 mm to 3.5 mm
plugs to connect the headphone out or audio
line-out of the external device to the Line input
button or
socket of this unit.
Radio operation
Tuner operations
• Press
• Press BAND button to switch between AM
and FM radio bands.
• Adjust the program by rotating TUNER
regulator.
• Use VOLUME regulator to adjust volume
level.
• To obtain better FM signal reception,
extend the FM wire antenna to its full length.
Instruction manual
button to
button to show the current
button to turn the radio on or off.
button
3