Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Accton Technology Cheetah PCI Adapter
Summary of Contents for Accton Technology Cheetah PCI Adapter
- Page 1 Cheetah PCI Adapter Quick Installation Guide...
-
Page 3: Package Checklist
Note that new or updated driver information is available via Accton’s Web site. To order the optional boot ROM, SW7149, contact your local Accton dealer or reseller. Please fill out and return the registration card to Accton. The Cheetah PCI Adapter is covered by a limited lifetime warranty. -
Page 4: Hardware Description
The Cheetah PCI Adapter is equipped with : • 1 10BASE-T/100BASE-TX RJ-45 port • 1 3-pin connector for Wake-On-LAN cable • 1 Socket for optional boot ROM • 3 LED indicators The components of the Cheetah PCI Adapter are shown in the figure below:... -
Page 5: Led Indicators
Cheetah PCI Adapter LED Indicators The following table describes the operation of the Cheetah PCI Adapter status LEDs: d i l : f f i t c d i l d i l : f f i t c d i l... -
Page 6: Installation
Quick Installation Guide Installation Warnings: · Network cards are sensitive to static electricity. To protect the card, avoid touching its electrical components and always touch the metal chassis of your computer before handling the card. · Backup your driver diskette and use the copy as the working diskette to protect the original from accidental damage. -
Page 7: Setup Program
Cheetah PCI Adapter 5. Connect the Cheetah PCI Adapter directly to a 10BASE-T or 100BASE-TX hub or switch using UTP cable (Category 3, 4 or 5 for 10BASE-T; Category 5 for 100BASE-TX). The maximum allowable length of UTP cable connections is 100 meters (328 ft.). - Page 8 “Setup New Configuration” screen (see below). 4. In the event of a problem with the Cheetah PCI Adapter, use the Setup Program to run the card’s built-in diagnostics (see the “SET1207D.TXT” file for specific instructions).
-
Page 9: Troubleshooting
Cheetah PCI Adapter computer and run the diagnostics again to see if the problem persists. If it does, record the failure indicated and contact Accton’s Technical Support for assistance. Troubleshooting Check the following troubleshooting items before contacting Accton Technical Support. -
Page 10: Adapter Installation Problems
Setup, make sure the jumper and BIOS settings match. Adapter Installation Problems If your computer can’t find the Cheetah PCI Adapter or the network driver doesn’t install correctly, check the following: • Make sure the adapter is securely seated in the PCI slot. -
Page 11: Fcc Class B Certification
Cheetah PCI Adapter • Make sure the correct software driver is installed for your operating system. If necessary, try reinstalling the driver. • Make sure the computer and other network devices are receiving power. • If the adapter’s speed or duplex mode has been configured manually, check that it matches that of the attached network device port. -
Page 12: Csa Statement (Canada)
Quick Installation Guide CSA Statement (Canada) This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of Industry Canada. Le présent appareil numérique n’émet pas de bruits radio- électriques dépassant les limites applicables aux appareils numériques de la classe B prescrites dens le Règlement sur le brouillage radioélectrique édicté... -
Page 13: Specifications
Cheetah PCI Adapter Specifications General Specifications ° ° ° ° Software Drivers... -
Page 14: Warranty
IT ANY OTHER LIABILITY. Copyright Copyright © 1999 by Accton Technology Corporation. All rights reserved. No part of this document may be copied or reproduced in any form or by any means without the prior written consent of Accton Technology Corporation.