RGBlink DV4 Quick Start Manual

DV4 Quick Start
For full installation, configuration, and operation details, please refer to
NOTE
the DV4 user manual, which is available at www.rgblink.com.
This guide provides quick start instructions for an experienced installer
to set up and operate the DV4.
Installation and cabling features
Back Panel
Connections
1
DVI Input
DVI Output
2
3
Outputs of Sending Card
5
Step 1-Mounting
Turn off or disconnect all equipment power sources.
Step 2-DVI Input
Use to input DVI from DVI player or
computer with DVI connector.
Step 3-DVI Output
Connect to the input port of sending card,
output DVI signal to DVI input port of
sending card.
Step 4-DVI Input Port of Sending Card
Connect to DVI output, and receive the
signal from DVI output.
Step 5-Outputs of Sending Card
Connect to LED display.
Step 6-Power
Plug in power cord which has IEC connector, DV4
supports AC power from 100 to 240V, 50-60Hz, which
means world wide compatible.
Power On
Connect one end of the power with the device, the other
end into a socket, and push power switch to ON
position, then the device will work normally.
Address: S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone, Xiamen, Fujian Province, P.R.C
Tel: 00865925771197
Email: rgblinkcs@gmail.com
VIEW SIZE THE WORLD
DVI Input Port of
4 6
Sending Card
Switch
7
Power
8
Fax:00865925771202
http://www.rgblink.cn
Operation Manual
How to Connect
Operation steps are as follows:
1. Connect the device or computer with DVI interface
to the DVI input interface in above row of DV4 with
DVI cable.
2. Connect each DVI output interface to the
corresponding DVI input interface of sending card
with DVI cable.
3. Connect outputs of sending card to LED display
with cable.
4. Plug in power cord with IEC connector.
Same operation with the below row interfaces.
Shown as follows:
How to Work
Push power button to ON position, the device will
operate as follows:
1. Input DVI signal, each DVI input interface will
output the signal to the 2 output interfaces.
2. Output interfaces output the signal to corresponding
inputs of sending card.
3. Inputs of sending card output the signal to outputs
of sending card.
4. Outputs of sending card output the signal to LED
display.
DV4 Quick Start
Rev 1.0
Page 1 of 2