LG DLGY1702 series Owner's Manual page 25

Installation Test (Duct check) (cont.)
Error Code
or
connected correctly, or house power
supply is incorrect.
or or
tripped, or power outage has occurred.
If the test displays four bars, check the exhaust system
for restrictions and damage. Repair or replace the
exhaust system as needed.
NOTE
When the dryer is first installed, this test should be
performed to alert you to any existing problems with
the exhaust duct in your home. However, since the
test performed during normal operation provides
more accurate information on the condition of the
exhaust duct than does the installation test, the
number of bars displayed during the two tests may
not be the same.
Do not interrupt the test cycle, as this could result in
the wrong results.
Even if no bars are displayed during the test cycle,
some restrictions may still be present in the exhaust
system. Refer to the
this manual for complete exhaust system and venting
requirements.
Your dryer features Flow Sense™, an innovative
sensing system that automatically detects blockages
clean of lint buildup and free of restrictions allows
clothes to dry faster and reduces energy use.
Possible Causes
section of
INSTALLATION INSTRUCTIONS
Solutions
service.
service.
Check the power supply or the
connection of power cord to the
terminal block. Refer to the
for complete instructions.
the fuse capacity.
If the problem is a circuit overload, have it corrected
by a qualified electrician.
Avoid long runs or runs with multiple elbows or
bends.
Excess or crushed
transition duct
Check for blockages and lint buildup.
Make sure the ductwork is not crushed or restricted.
25
section of this manual
Too many elbows or
exhaust too long
Lint buildup
or blockage
Crushed or
damaged
exhaust