1. Manuals
  2. Brands
  3. Ridemakerz Manuals
  4. Motorized Toy Car
  5. RIDE
  6. Manual

Ridemakerz RIDE Manual

Ridemakerz ride monster car manual
Hide thumbs

Advertisement

Table of Contents

RIDE MANUAL
OWNERZ NAME
MAKE
RIDEMAKERZ.COM
BUMPER-TO-BUMPER
PIT CHALLENGE TIME
MODEL
1-866-58-RIDEZ (74339)

Advertisement

Table of Contents
loading

Summary of Contents for Ridemakerz RIDE

  • Page 1 BUMPER-TO-BUMPER RIDE MANUAL OWNERZ NAME PIT CHALLENGE TIME MAKE MODEL RIDEMAKERZ.COM 1-866-58-RIDEZ (74339)

  • Page 2: Table Of Contents

    RIDEMAKERZ gladly accepts returns for exchange or refund within replacement and return shipment will be free of charge. This 30 days. Please save your receipt, return it to a RIDEMAKERZ SHOP OUR TOLL FREE NUMBER warranty does not cover damage resulting from unauthorized...

  • Page 3: Safety Warnings

    • Different types of batteries, or new and used batteries are not your RIDE on the street or in a parking lot that is in use. harmful interference to radio communications. However, to be mixed.
  • Page 4 Install 4 new alkaline wire connector plug from the vehicle batteries. Follow directions inside the to the battery pack. Twist the locking battery compartment. tab to the locked position to hold the battery firmly in place. RIDEMAKERZ.COM 1-866-58-RIDEZ (74339)
  • Page 5 RZ Tool. and install 6 new alkaline batteries. to the battery pack. Twist the locking Lock oval latch. tab to the locked position to hold the battery pack firmly in place. RIDEMAKERZ.COM 1-866-58-RIDEZ (74339)

  • Page 6: Radio Control

    If this occurs, consider RIDE body. moving to a location free from these potential obstructions. Each RIDE must be set to a different channel. If they are not, TWO CHASSIZ FREQUENCIES one controller might operate more than one RIDE, or the RIDEZ might not respond to the controller at all.

  • Page 7: Ridesoundz

    RIDESOUNDZ 7 ridesoundz Remove RIDESOUNDZ compartment Insert the RIDESOUNDZ into the port on the RIDE Replace the RIDESOUNDZ compartment chassiz and press in firmly until the RIDESOUNDZ cover by sliding it to the left and cover inserting it and sliding it to the has been inserted fully into the port.

  • Page 8: Ride Assembly (Street)

    & back treadz), so there are two different chassiz lengths to fit each down (Place on a surface that won’t scratch your RIDE). RIDE. Your chassiz wheelbase must match your RIDE wheelbase. RIDE ASSEMBLY 2. Locate the arrow on your chassiz la- beled “FRONT”...
  • Page 9 1. With you thumb, apply pressure to the back side of flat, face up. your TREAD. 2. Place the wheel onto your RIDE by pressing it 2. Press the WHEEL into the center of the TREAD, onto the wheel hub.

  • Page 10: Ride Assembly (Monster)

    & back treadz), so there are two different chassiz lengths to fit each down (Place on a surface that won’t scratch your RIDE). RIDE. Your chassiz wheelbase must match your RIDE wheelbase. RIDE ASSEMBLY 2. Locate the arrow on your chassiz la- beled “FRONT”...
  • Page 11 1. With you thumb, apply pressure to the back side of flat, face up. your TREAD. 2. Place the wheel onto your RIDE by pressing it 2. Press the WHEEL into the center of the TREAD, onto the wheel hub.

  • Page 12: Accessories

    12 ACCESSORIES 649 MILLION MAGNETS WAYS TO BUILD YOUR RIDE You can trick-it-out with bumper-to-bumper accessories. It’s eazy with built-in hood and rooftop magnets. Plus, each chassiz is equipped with slots on the front, rear, and sides where accessories are easily placed and switched out.
  • Page 13 ACCESSORIES 13 SLOTS & TABS Slots are located along the perimeter of each chassiz. Each accessory has tabs that slide into the slots to hold them in place. RIDEMAKERZ.COM 1-866-58-RIDEZ (74339)
  • Page 14 14 CONTROLS driving MONSTER This controller works differently. The left toggle switch operates the left side of your RIDE. The right toggle switch IT TAKES A LITTLE PRACTICE operates the right side of your RIDE. YOUR RIDE BUT YOU’LL MASTER THE MONSTER - Make sure the vehicle and transmitter are switched ON.

  • Page 15: Frequently Asked Questions 15

    My radio control (R/C) RIDE won’t work at all. There could be several reasons for this. If your R/C RIDE won’t work, check the following: 1) Make sure the ON/OFF switches on both the vehicle and the transmitter is set to the ON position. When the transmitter is turned ON, a red light will glow in the center of the unit.
  • Page 16 RIDEMAKERZ R/C vehicle has three Band settings. A transmitter set to Band 1 will only operate a vehicle set to Band 1. A transmitter set to Band 2 will only operate a vehicle set to Band 2, and so on.
  • Page 17 With your thumb and index finger, grab the RIDESOUNDZ by the thin center area and pull straight up to remove it. Blow into both the connector slot on the chassiz and the RIDE- SOUNDZ itself to remove any dust. Reinsert the RIDESOUNDZ, pressing firmly. Reattach the battery compartment cover or the RIDESOUNDZ compartment cover.
  • Page 18 RIDEMAKERZ.COM 1-866-58-RIDEZ (74339)

Table of Contents