Download
Share
Print this page
  1. Manuals
  2. Brands
  3. McCrypt Manuals
  4. Speakers
  5. S.T.E.V.E. 15"
  6. User manual

McCrypt S.T.E.V.E. 15" User Manual

Active monitor box mccrypt s.t.e.v.e. 15"
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
Active Monitor Box McCrypt S.T.E.V.E. 15"
Order No. 30 17 06
1

Advertisement

loading

Summary of Contents for McCrypt S.T.E.V.E. 15"

  • Page 1 Active Monitor Box McCrypt S.T.E.V.E. 15” Order No. 30 17 06...
  • Page 2 Only low voltage (line) audio signals should be fed to the inputs of the amplifier. The McCrypt Active Monitor can be used as a monitor in studio, or live on stage. It can also be used in pairs as a small PA System, or linked together to cover a large area.
  • Page 3 Basic Functions Mic1 Input Microphone inputs 1 Mic1 Level Input gain control Mic2 Input Microphone inputs 2 Mic2 Level Input gain control Line Level Input gain control Line Input Stereo (R & L internally mixed to mono) Line Input XLR Volume Master output control Treble Master control Bass Master control...
  • Page 4 Safety Warning Damage caused by not following the manual instructions renders the guarantee void. We will not be responsible for any damage caused by neglecting these operating procedures! We cannot be held responsible for damage caused by neglecting these safety instructions! The Guarantee, in this case, also becomes void! Important instructions are marked by an exclamation mark in a triangle.
  • Page 5 Connect a sound source to the Line Input and slowly turn the level control up until the volume is loud enough. Line Out Connect, using a XLR or jack cable, to the Line Input of another McCrypt Active Monitor or similar equipment. Ground Lift When the Active Monitor is used alone, the Ground Lift switch should always be Off.
  • Page 6 condense onto the cold metal and cause short circuiting and damage to the components. Do not connect to the mains, or switch on the power until the equipment has reached room temperature! Do not handle the power cable with wet hands! Never pull the plugs out of equipment by the cable.
  • Page 7 Always observe the safety precautions! Problem • Monitor does not work, no power Is it switched on? Is the power cable properly indicator connected? (at both ends) • Is the fuse OK? • Does the wall socket have power? • Has the internal protection activated itself? (overheating?) If so, switch the equipment off for a few minutes then switch on again.