Advertisement
Quick Links
When installing and using this electrical equipment, basic safety precautions should
always be followed, including the following:
1. READ AND FOLLOW ALL INSTRUCTIONS
2. WARNING – To reduce the risk of injury, do not permit children to use this
product unless they are closely supervised at all times.
3.
Do not install within an outer enclosure unless so marked.
4. SAVE THESE INSTRUCTIONS.
WARNING – All electrical wiring of the motor installation must be done by a qualified
electrician in accordance with applicable electrical codes. Before working on any motor,
be certain that the source of electrical power is off at the main junction box.
BONDING WIRE – Upon installation of the pump, the motor must be used with a No. 8
AWG (8.4mm2) solid copper conductor per National Electric Code. The connection
should be from the accessible wire connector on the motor to all metal parts of the water
garden and to all electrical equipment, metal conduit and metal piping within 5 feet
(1.5m) of the inside walls of the water garden, when the motor is installed within 5 feet of
the inside walls of the water garden.
NOTE: For electrical connection, see wiring diagram on motor rating plate.
CAUTION: This Pump Has Been Evaluated for Use With Water Only.
WARNING Risk of Electric Shock – This pump is supplied with a grounding conductor
and grounding-type attachment plug. To reduce the risk of electric shock, be certain that
it is connected to a properly grounded, grounding-type receptacle. (56.1 b)
OWNER'S MANUAL
EVOLUTION 5200, 6400, 7800 & 9600
IMPORTANT SAFETY INSTRUCTIONS
SERIES PUMPS
Advertisement
Related Manuals for Advantage Manufacturing EVOLUTION 5200
Summary of Contents for Advantage Manufacturing EVOLUTION 5200
- Page 1 OWNER’S MANUAL EVOLUTION 5200, 6400, 7800 & 9600 SERIES PUMPS IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: 1. READ AND FOLLOW ALL INSTRUCTIONS 2. WARNING – To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times.
-
Page 2: Installation
INSTALLATION & OPERATING INSTRUCTIONS GENERAL Your Evolution pump has been quality built and III. WINTERIZATION engineered to give maximum efficiency under To prevent damage during freezing conditions, turn normal water pumping conditions. Consult the off all electrical power. Drain thoroughly and clean manufacturer for any other applications. -
Page 3: Troubleshooting
TROUBLESHOOTING MOTOR WILL NOT START: Check Circuit Breakers Check for incorrect or loose wire connections. Make sure the correct power supply is being used. Any on/off switch or pneumatic switch should be in the “on” mode. MOTOR OVERHEATING AND CYCLING ON AND OFF: Check for incorrect or loose wire connections. - Page 4 EVOLUTION ASSEMBLY INSTRUCTIONS (Including Impeller and Seal Replacement) WARNING: ALWAYS DISCONNECT THE ELECTRICAL POWER FROM THE PUMP MOTOR BEFORE PERFORMING ANY WORK ON THE PUMP UNIT. To Disassemble Pump: CAUTION: DRAIN THE WATER FROM THE PLUMBING LINES BEFORE DISCONNECTING THE PUMP, ALWAYS PROTECT THE MOTOR FROM POSSIBLE WATER DAMAGE.
- Page 5 Installing the New Seal Assemblies: Seal Rotating Assembly: Carbon Disk, Spring, Steel Collar, Rubber ring Before installing the seal rotating assembly, apply water to the shaft sleeve. Grasp the assembly with the carbon disk facing outward. Insert the impeller sleeve through the steel collar side.
- Page 6 If within the first two years, any such improper maintenance. products shall prove defective, it shall be repaired or 2. Any items manufactured by other companies replaced at Advantage Manufacturing Inc.’s option and used by Advantage Manufacturing, Inc. as follows:...