Table of Contents
Advertisement
Quick Links
Introduction
The following is intended as a guide to installation and initial setup of the standard 20"
VideoFlyer, an Internet connected digital video player and display.
This Guide covers:
Mounting information: How to attach the unit to a fixture
•
Installation of a Compact Flash (CF) memory card
•
Power: On/off, power considerations
•
Setup using the optional 8 segment touch screen
•
Operation: How to play video on VideoFlyer
•
Preparation
It is advisable to do a quick check that the display is working properly prior to installation. Simply
install the CF card as explained below and then power on. If the unit powers up then proceed with
installation.
CF Card Installation
Remove the access cover on the rear of the display unit, see diagram
•
The CF card should be inserted carefully with the label side visible. WARNING: Do not force
•
the CF card. Forcing the CF card can damage the connector pins in the display unit and result
in expensive repairs.
To eject the card push the Eject button as shown in the diagram.
•
Power in
RS-232
Test / Normal switch
(Default set to Normal)
20" VideoFlyer User Guide
VideoFlyer 20"
Model : VF-200
User Guide
DC 12V
RS - 232
No rmal
Test
.
CF Card
compartment
Volume
Vol ume
Control
July 2006 v.m4.0
Advertisement
Table of Contents
Related Manuals for Digital View VideoFlyer VF-200
Summary of Contents for Digital View VideoFlyer VF-200
- Page 1 VideoFlyer 20” Model : VF-200 User Guide Introduction The following is intended as a guide to installation and initial setup of the standard 20” VideoFlyer, an Internet connected digital video player and display. This Guide covers: Mounting information: How to attach the unit to a fixture •...
- Page 2 B available. 50mm (C) Standard VESA VESA Digital View Use mounting holes reference A or B, ie 100mm and 75mm spacing Screws are 4mm diameter Power The display system is supplied with an AC to DC power adaptor. This should be connected to the mains.
- Page 3 Display Setup (touch screen versions only) 1. The touch screen, if fitted, has 8 touch segments (buttons) which can be programmed with DV Studio software to perform in VCD player mode or specific track select functions. Config mode To enter the Config. Mode, holding the button 8 and power up. VOLUME VER 4.10 Power on...
- Page 4 Operation CAUTION: Never connect or disconnect parts of the system when the system is powered up as this may cause serious damage. All the features described in the following points can be set by the DV Studio software. See DV Studio User Guide for more details.
- Page 5 SAFETY NOTICES WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE RISK OF ELECTRIC SHOCK DO NOT OPEN Whilst care has been taken to provide as much detail as possible for use of this product it cannot be relied upon as an exhaustive source of information.
Need help?
Do you have a question about the VideoFlyer VF-200 and is the answer not in the manual?
Questions and answers