Related Manuals for Albrecht BPA 300
Summary of Contents for Albrecht BPA 300
- Page 1 BPA 300 Headset + Adapter for Headset Communication ® to Bluetooth - Devices...
- Page 2 Depending on the version, a suitable helmet headset for closed helmets (article. No. 15500) or open helmets (article No. 15510) is supplied with the adapter. With the BPA 300 you can answer phone calls from your mobile phone,...
- Page 3 You can plug the 6 pin male plug of the wired helmet set into the 6 pin female plug of the adapter. The helmet set can be ALBRECHT CHS 300, OHS 500, OHS 550. Other headsets like MHS 300 or MHS 301 headsets can be connected only if already equipped with 6 pin male plugs.
- Page 4 • After switching on, the device remains in Standby mode and flashes every 3 sec. Turning off the adapter: • Press and hold the button for approximately 3 sec. again, LED will flash 3 x red • The complete headset will be turned off and the LED indicator will stop flashing. Pairing the wireless adapter + headset with a Phone, Navigator or other Adapter The wireless adapter with the headset must be paired with the other Bluetooth device before it can be used for the first time.
-
Page 5: Important Notes
Navigator with the headset adapter! • In case of BPA 100 / BPA 200 / BPA 300 or Midland 445 BT / Midland G8BT there is no need to enter any PIN code. The BPA 300 is automatically detected after starting the pairing mode. - Page 6 Call transfer to mobile phone During a phone communication, you can transfer the call back to your mobile phone by pressing 2 x shortly on the BPA 300 button Volume control You can adjust the volume of the headset with the volume buttons at the mobile phone, radio...
- Page 7 01805- 012204 (0.14 Euro per minute from German fixed network; from mobile phones the costs may be different). Please contact your local distributor, if you should have bought your BPA 300 in another country.
- Page 8 Important Note If the device has not been used for a longer time it may occur that the built-in rechargeable battery has been deep discharged. In this state the charging-LED will not turn on if the charger is connected. But the device is not defective, please keep the charger connected and wait for about 15min.
Need help?
Do you have a question about the BPA 300 and is the answer not in the manual?
Questions and answers