Related Manuals for Conrad FS20 RPT
Summary of Contents for Conrad FS20 RPT
- Page 1 OPERATING INSTRUCTIONS Version 12/06 Radio repeater „FS20 RPT“ Item no. 62 30 06...
- Page 2 Should you have any further questions, please contact our technical advisory service: Germany: Tel. no.: +49 9604 / 40 88 80 Fax. no.: +49 9604 / 40 88 48 e-mail: tkb@conrad.de Mon. to Thur. 8.00am to 4.30pm Fri. 8.00am to 2.00pm...
-
Page 3: Table Of Contents
12. Declaration of conformity (DOC) ................. 10 1. Prescribed use The sole purpose of the ‘FS20 RPT‘ radio repeater is to increase the range of transmitters from the FS20 wireless control system. The repeater should only to be used in dry indoor areas. -
Page 4: Scope Of Delivery
2. Scope of delivery • Repeater • User manual 3. Explanation of icons The icon with a lightning flash in a triangle is used to alert you to potential personal injury hazards such as electric shock. This icon with an exclamation mark in a triangle points to particular dangers associated with the handling, function or operation of the product. -
Page 5: Safety Instructions
5. Safety instructions The product’s guarantee becomes invalid if the product is damaged as a result of failure to observe these operating instructions. We do not assume any liability for any resulting damages! Nor do we assume liability for damage to property or personal injury caused by improper use or failure to observe the safety instructions. -
Page 6: Functionality
6. Functionality The repeater serves to increase the range of transmitters from the FS20 wireless control system. Radio commands sent by these transmitters can be repeated up to two times so that the range of the original transmission signal can be tripled (maximum) when two repeaters are used. Figure 1: Example application The repeater can also be used to rectify critical transmission paths in steel-reinforced buildings, environments with high levels of interference etc. -
Page 7: Operation
7. Operation Simply plug the repeater into a socket (230V~/50Hz) with an earth connector. The repeater is then immediately ready for use. The repeater forwards a received command from the FS20 wireless control system with a repeater identifier. A slight time delay occurs as a result of the brief buffering of the signal. The repeater’s socket allows network consumer loads to be connected according to the load capacity of the respective mains supply circuit. -
Page 8: Maintenance And Cleaning
If the product is not operated for a longer period of time, disconnect it from the voltage supply, removing it from the socket. Avoid the following adverse ambient conditions at the installation location or during transport: - Moisture or excessive air humidity - Extreme cold or heat - Dust or flammable gases, vapours or solvents - Strong vibrations... -
Page 9: Tips And Notes
11. Tips and notes Ranges and interference • The FS20 wireless control system works in the 868MHz range, which is also used by other radio services. Therefore devices that operate on the same or neighbouring frequency may restrict both its operation and its range. •... -
Page 10: Declaration Of Conformity (Doc)
12. Declaration of conformity (DOC) We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau (Germany), hereby declare that this product complies with the fundamental requirements and other relevant regulations of directive 1999/5/EG. You can find the declaration of conformity for this product at www.conrad.com. - Page 12 100% The operating instructions reflect the current technical specifications at recycling time of print.We reserve the right to change the technical or physical paper. specifications. Bleached without © Copyright 2006 by Conrad Electronic SE. Printed in Germany. chlorine.
Need help?
Do you have a question about the FS20 RPT and is the answer not in the manual?
Questions and answers