Network Connection; Wireless Network Connection; Diagram 4; Naim App Setup Screen - NAIM MU-SO Reference Manual

In order to play streamed audio files and internet radio
stations mu-so must be connected to the internet via a local
network. Mu-so can be connected to a local network via
either a wired or wireless connection to a network router.
The following paragraphs describe the procedures for
wireless and wired connection.
Note: Mu-so is configured by default to communicate
with TCP/IP networks automatically using the standard
DHCP protocol. Mu-so can be configured to use a fixed IP
address via is internal web setup pages. See Section 2.2
for more information.
Note: If your mu-so has been previously used it is
good practice to return it to its default settings before
attempting to connecting it to your network. The factory
default procedure will erase any existing user and network
settings and restore the default iRadio presets. See
Section 6.6 for more information.
The indicator adjacent to the factory defaults button on the
mu-so right-hand side panel illuminates to communicate
different network and functional states. The illumination is
listed in the following table:
Illumination
Off
White
Orange
Purple
Purple (flashing)
Blue
Red (flashing)

2.1 Wireless Network Connection

In order for mu-so to connect to the internet via a local
wireless network it must be configured with the wireless
network name (SSID) and password (security key). There
are three different methods achieving this. The method
you choose will depend on personal preference and
convenience.
Note: Mu-so is compatible with the 802.11b and 802.11g
Wi-Fi standards.

2. Network Connection

Network and Functional State
Deep sleep/off
Network connected
Network connection starting
Wireless connection configured
but network not found
Wireless setup mode
Firmware update underway or
unit in recovery mode
System fault or amplifier overload
(contact your retailer or mu-so
suport)
2.1.1 Wireless Setup Using the Naim app
The Naim app incorporates a wireless setup routine that
will guide you through the process of connecting mu-so
wirelessly to your local network. If you have not already
downloaded and installed the Naim app you should do
so now. Follow the steps below to implement Naim app
wireless setup routine.
• Ensure that the iOS or Android device on which you
have installed the Naim app is connected to the same
wireless network you wish your mu-so to use.
• Open the Naim app and select Setup new mu-so.
• Follow the on-screen instructions to connect mu-so to
the wireless network. Diagram 4 illustrates the Naim
app setup page.

Diagram 4

Naim app Welcome
screen
4
Rooms
Setup new mu-so