Advertisement
DEFINITIONS FOR ILLUMINATED LED INDICATORS
Power
Using
On
Battery
On
Off
Off
Off
On
Off
Flash
Off
On
Off
On
Off
On
Off
Off
On
Off
On
Off
Off
Off
On
Off
Off
Off
On/Off
On/Off
On/Off
Off
On/Off
On/Off
On/Off
TECHNICAL SPECIFICATIONS
Model
Capacity (VA)
Capacity (Watts)
Input
Input Voltage Range
Frequency Range
Output
On Battery Output Voltage
On Battery Output Frequency
Overload Protection
Surge Protection and Filtering
Lightning / Surge Protection
Network Protection
Physical
Total # of UPS Receptacles
Maximum Dimensions
Weight (Kg)
Battery
Sealed Maintenance Free Lead Acid Battery
12V / 8AHx2
Hot Swappable Battery
Typical Recharge Time
Warning Diagnostics
Indicators
Audible Alarms
Environmental
Operating Temperature
Operating Relative Humidity
Communication
SeeUPS2020 Software
Management
Auto-Charger/ Auto-Restart/ USB
SNMP/HTTP Network
Condition
Circuit
Alarm
Breaker
Off
Set
Normal
Max. boost 14% of input voltage for output
Off
Set
regulation while input voltage is from 6%
to 17% under nominal.
Max. boost 30% of input voltage for output
Off
Set
regulation while input voltage is from 18%
to 29% under nominal.
Max. buck 12% of input voltage for output
Off
Set
regulation while input voltage is from 8%
to 25% over nominal.
Two
Utility Failure - The UPS is providing battery
Set
Beeps
power to the Battery-Power Supplied outlets.
Utility Failure - The UPS is providing battery
Rapid
Set
power. The rapid beeps indicate the battery will
Beeps
run out of charge within a few minutes.
Two
Overload- Turn the UPS off and unplug at
beeps or
least one piece of equipment from the
Set
rapid
UPS. Wait 5 seconds, reset the circuit
beeps
breaker and restart the UPS.
Overload- Turn the UPS off and unplug at
Long
least one piece of equipment from the
Up
Beep
UPS. Wait 5 seconds, reset the circuit
breaker and restart the UPS.
LI800
LI1100
800VA
1100VA
550W
700W
85Vac-150Vac
50/60 Hz +/- 3Hz
Pure Sine Wave at 120Vac +/- 7%
47-53Hz for 50Hz nominal, 57-63Hz for 60Hz nominal
On Utility: Circuit Breaker, On Battery: Internal Current Limiting
Yes
RJ45 (One In/One Out)
(7) NEMA 5-15R
30.9cm*14.1cm*18.4cm
12.8
14.6
12V / 10AHx2
12V / 10AHx2
Yes
8 Hours
Power On, Using Battery, Boost, Buck
On Battery, Low Battery, Overload
+32°F to 95°F ( 0°C to 35°C )
0 to 95% NON-CONDENSING
Windows 98/ME/2000/NT/XP, Server 2003, Mac OSX, Linux
Yes
Optional
In purchasing LI800 / LI1100 / LI1500 in the United States or Canada, the original end user receives a Limited Warranty from Legacy
Power Conversion, Inc. (for ease of reading, referred to as "Legacy"). The Limited Warranty is intended to be the original end-user's
exclusive rights and remedies.
Limited Warranty. The original end user (referred to as the "Initial Customer") receives an express limited warranty (referred to as the
"Limited Warranty") for the LI800 / LI1100 LI1500 purchased from Legacy (referred to as the "Product"). The Limited Warranty is for the
Product itself. The Limited Warranty is subject to the terms set forth below. Additionally, State or Provincial law may adjust the terms of
the Limited Warranty or the State or Province may impose additional obligations, or additional "implied warranties." To the extent
necessary to comply with those laws, the terms of the Limited Warranty should be read to adjust to those requirements only to the
extent necessary to comply with such local law.
If you are an Initial Customer, you are asked to read the following terms and conditions carefully before using the Product. By using the
Product you consent to be bound by and become a party to the Limited Warranty. If you do not agree to the terms and conditions of the
Limited Warranty, you should return the Product for a full refund prior to using it.
REGISTRATION
Legacy requests that you complete and return the Warranty Registration Card enclosed with the Product or register the Product at its
website (www.lpc-ups.com) to establish that you are the Initial Customer of the Product, and therefore entitled coverage under the
Limited Warranty. (Registration is not required for Limited Warranty coverage, but note if you do not complete a registration card you
will be required to provide proof of purchase, as described below, to have the benefits of this Limited Warranty.)
LIMITED WARRANTY
Legacy warrants to you, the Initial Purchaser, that the Product will be free from defects in material and workmanship for three years
from the date of original purchase, subject to the terms of this Limited Warranty. This Limited Warranty gives you specific rights, and
you may have other rights, which vary from State to State or Province to Province.
Any Implied Warranty of Merchantability or for Fitness for a Particular Purpose, if applicable to the Product, is limited in duration to the
period of ownership by the Initial Customer. This provision shall NOT create any Implied Warranty or Merchantability or of Fitness for a
Particular Purpose that would not otherwise apply to the Product. NOTE: Some States and Provinces do not allow limitations on
how long an implied warranty lasts, so the above limitation may not apply to you.
To be covered you must still be the owner of the Product at the time of the failure that results in the claim made under this Limited
Warranty.
Exclusive Remedies Under Limited Warranty.
Your exclusive remedy and Legacys' sole obligations are as follows for the Product:
If (a) the Legacy Product you purchased and still own is defective in material or workmanship under this Limited Warranty or any
applicable warranty imposed by law, and (b) all Limited Warranty requirements have been met, Legacy will repair or replace the
Product if it proves to be defective in material or workmanship during the Warranty Period.
Making a Limited Warranty Claim.
LI1500T
To make a Limited Warranty claim on a Product, you must do the following:
1500VA
1.
Complete and return the Legacy Warranty Registration Card, or provide reasonable proof of purchase (for example, a sales
1000W
receipt) that establishes you as the Initial Customer (the original end-user consumer purchaser) of the Product and prove that
the Product was purchased within three (3) years of the event for which you want to make a claim for warranty service.
2.
Call Legacy at (608) 565-5878 or (800) 859-5711 (toll free), write to Legacy Power Conversion at N9246 Hwy 80 South, Suite 7,
Necedah, WI 54646, or e-mail Legacy at service@lpc-ups.com, within ten (10) days of the event for which you want to make a
claim.
3.
When you contact Legacy, identify the Product, the Purchase Date, and request Return Materials Authorization (RMA)
information from Legacy.
4.
Pack and ship the Product to Legacy as instructed in your RMA. Show the RMA code on the shipping label or include it with the
Product.
You MUST prepay all shipping costs and you are responsible for packaging and shipment.
Legacy will inspect and examine the Product within ten (10) days of receipt. If the Product is not as warranted, Legacy will repair or
replace the Product and return it to you at Legacy's expense, or, if Legacy is unable to or decides not to repair or replace the Product
(if defective) within a reasonable time, Legacy will refund to you the full purchase price you paid for the Product (purchase receipt
showing price paid is required).
CONDITIONS TO THE LIMITED WARRANTY
The Limited Warranty is the only and the exclusive express warranty of Legacy with respect to the Product. This exclusion of other
15.5
express warranties applies to written and oral express warranties.
LIMITATION: THE LIMITED WARRANTY DOES NOT COVER
The Limited Warranty is intended to exclusive rights and remedies and replace any other rights, to the extent allowed by law.
1.
As to the Legacy Product, the limited warranty does not cover or apply to: misuse, modification, operation or storage outside
environmental limits for the Products, in transit, in shipment, or in storage, damage or deterioration, improper operation or
maintenance, or use with items or equipment not designed or intended for use with the product.
The Limited Warranty Does Not Apply Unless The Initial Customer:
1.
Has properly connected the Product and the Connected Equipment to properly wired and grounded outlets (including
compliance with electrical and safety codes of the most current electrical code (ANS/NFPA 70), without the use of any adapters,
extension cords of other connectors.
2.
Has provided a suitable and proper environment for use and installation of the Product and Connected Equipment.
3.
Has properly installed and operated the Legacy Product and Connected equipment.
4.
Has operated the Product at all times within the limitations on the Product's VA capacity as stated in this User Manual.
Legacy Does Not Cover or Undertake Any Liability in Any Event for Any of the Following:
1.
Loss of or damage to data, records, or software or the restoration of data or records, or the reinstallation of software.
2.
Damage from causes other than AC Power Line Transients, spikes, or surges on properly installed, grounded and
code-compliant 120 volt power lines in the United States and Canada; transients, surges or spikes on standard telephone land
lines, PBX telephone equipment lines or Ethernet lines, when properly installed and connected.
3.
Damage from any circumstance described as excluded above with respect to the product.
4.
Damages from fire, flood, wind, rain, rising water, leakage or breakage of plumbing, abuse, misuse or alteration of either the
product or the Connected Equipment.
Exclusion of Consequential and Other Damages.
The sole and exclusive remedies of the Initial Customer are those provided by the Limited Warranty. Legacy excludes any liability for
personal injury under the Limited Warranty. Legacy excludes any liability for direct, indirect, special, incidental or consequential
damages, whether for damage to or loss of property, loss of profits, business interruption, loss of information or data. This exclusion
applies even though damage or loss is caused by negligence or other fault. NOTE: Some States or Provinces do not allow the
exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you.
DO NOT USE FOR HIGH RISK ACTIVITIES.
Legacy does not sell the Products for use in high-risk activities. The Product is not designed or intended for use in hazardous
environments requiring fail-safe performance, including the operation of nuclear facilities, aircraft navigation or communication
systems, air traffic control, weapons systems, life support or for use in any circumstance in which the failure of the Product could lead
directly to death, personal injury, or severe physical or property damage, or that would affect operation or safety of life support device
(collectively, "High Risk Activities"). Legacy expressly disclaims any express or implied warranty of fitness for High Risk Activities.
Legacy does not authorize use of any of its products use in any High Risk Activities. ANY SUCH USE IS IMPROPER AND IS A
MISUSE OF LEGACY PRODUCTS.
The Limited Warranty is governed by the laws of the United States and the State of Wisconsin, without reference to conflict of law
principles.
The application of the United Nations Convention of Contracts for the International Sale of Goods is expressly excluded.
Contact Information: Legacy's address is N9246 Hwy 80 South, Necedah, WI 54646 and its phone number is (608) 565-5878 or (800)
859-5711 (toll free). Legacy is the warrantor under this Limited Warranty. You may also contact Legacy on the Internet at
www.lpc-ups.com
.
LIMITED WARRANTY
Advertisement
