Table of Contents
Advertisement
XR10, XR20 & XR35 Blast Chiller Cabinets
LAE CIB-BC-PU1 Controller
English
April 2014 Issue 2
Call: +44 (0)843 216 8800
Fax: +44 (0)843 216 4700
www.fosterrefrigerator.co.uk
A Division of ITW Ltd
Foster Refrigerator
Oldmedow Road
King's Lynn
Norfolk, PE30 4JU
United Kingdom
Email: support@foster-uk.com
0772
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for xtra XR10
- Page 1 XR10, XR20 & XR35 Blast Chiller Cabinets LAE CIB-BC-PU1 Controller English A Division of ITW Ltd Foster Refrigerator Oldmedow Road King’s Lynn Norfolk, PE30 4JU United Kingdom April 2014 Issue 2 Call: +44 (0)843 216 8800 Fax: +44 (0)843 216 4700 Email: support@foster-uk.com...
- Page 2 Manual Information & Health & Safety Notes Environmental Management Policy with Disposal Requirements & General Electrical Safety Start Up & Operation 3 to 4 User Settings 4 to 5 Parameters 5 to 9 Technical Data for Blast Chiller 10 to 11 Servicing/Cleaning 12 to 14 Wiring Diagrams...
- Page 3 Product Support and Installation Contractors. Foster Refrigerator recognises that its activities, products and services can have an adverse impact upon the environment. The organisation is committed to implementing systems and controls to manage, reduce and eliminate its adverse environmental impacts wherever possible, and has formulated an Environmental Policy outlining our core aims.
- Page 4 Initial Set Up After unpacking, clean and allow the cabinet to stand for 2 hours before turning on (cleaning directions supplied within this manual). Ensure the cabinet is situated away from both hot and cold air sources, as this will affect its performance. Make sure that a minimum clearance of 10cm around the cabinet is available for ventilation and effective operation.
- Page 5 Button Description Button 1 – Decrease/ Information - This button is used as a decrease button and when pressed will show the current controller information i.e. time remaining when using a cycle and the current temperature. Button 2 – Choice of Cycle & Increase - From here you can select either ‘Soft Chill’ or ‘Defrost’ cycles.
- Page 6 Cabinets have their parameters set at point of build to the correct settings. If you wish to modify these set points then you should have a full understanding of their purpose and the following instructions. To amend any parameter press buttons 1 & 2 together for 5 seconds. Parameter ‘P01’...
- Page 11 XR10 & 20 Models XR10 XR20 Chilling Capacity per Cycle (Kg) Cooling Duty@ -15°C (Watts) Number of Fans Evaporating Temperature (°C) Compressor Hermetic Hermetic R404a R404a Gas Charge (Grams) Power Consumption (Watts) Current Consumption (Amps) Electrical Supply 230/1/50 13A 230/1/50 13A...
- Page 12 XR35 Model XR35 Chilling Capacity per Cycle (Kg) Cooling Duty@ -15°C (Watts) 2080 Number of Fans Evaporating Temperature (°C) Compressor Hermetic R404a Gas Charge (Grams) 1400 Power Consumption (Watts) 1600 Current Consumption (Amps) Electrical Supply 230/1/50 13A Total Heat Rejection (Watts) 5120 Maximum Ambient Room Temperature +43°C...
- Page 13 Remove both the fixing screws situated at the bottom on the unitcover. Tilt the cover forward and pull towards you. Refitting is the same action but in reverse ensuring the fixing screws are refit. XR10 & 20 Models Condenser Controller Electrics...
- Page 14 Cleaning the Condenser XR10 & XR20 models will clearly see the condenser after removal of the unitcover. XR35 model will have to also remove the Condenser Fan Plate and motor. To do this unscrew the two fixing screws positioned on The top of the condenser fan plate.
- Page 15 Door Removal Pivot Pivot Screw Top Hinge Bracket & fixing screws Firstly remove the unitcover (as described before), and unscrew the pivot screw from the top of the door. You can now remove the door from the upper hinge bracket. To refit reverse these instructions and make sure to refit the spacer washer.
- Page 16 Evaporator Coil Heater (option) Vo : Anti-smell fan (option) Blue Model Specific Details : Brown . without Cd1 for model XR10 . without Ve2 for models XR10, XR20 and XR35 Control Board Front USB Connector 15 | P a g e...
- Page 17 Fault Cause of Fault Action /Solution To Rectify Safety & Utility > Indicates a communication problem between the display PCB and the controller PCB. > Press any button to acknowledge the warning > Indicates a defrost cycle is in & clear the fault progress.
- Page 18 Before calling your supplier please make sure that: a) The plug has not come out of the socket and the mains power supply is on i.e. is the controller illuminated? b) Check to see if the unit is in standby c) The fuse has not blown d) The cabinet is positioned correctly –...
- Page 20 Tel: (49) 781 990 7840. Fax (49) 781 990 7844. Email: info@foster-gmbh.de Foster Refrigerator Oldmedow Road Kings Lynn Norfolk PE30 4JU Tel: 0843 216 8833 Fax: 0843 216 4707 Website: www.fosterrefrigerator.co.uk Email: support@foster-uk.com a Division of ‘ITW (UK) Ltd’ XR10 – XR35/SM 04/14v2 UK...
Need help?
Do you have a question about the XR10 and is the answer not in the manual?
Questions and answers