Related Manuals for Unitec EP-42F
Summary of Contents for Unitec EP-42F
- Page 1 OPERATION MANUAL Paper Folder EP-42F Read this Operation Manual before using this machine. Keep the Operation Manual with care in a fixed storage place so that it may be available whenever required.
-
Page 2: Safety Instructions
Safety Instructions Danger This Symbol stands for immediate danger threatening the life and health of persons. Disregarding these instructions may cause severe damage to health and even serious injuries. Caution This symbol stands for an endangering situation that may occur. Disregarding these instructions may lead to slight injuries or damage to property. - Page 3 Caution Do not let hairs, a necktie, or necklace hang above the drive of the machine. Doing so may cause an injury. Do not put the machine on an unstable place such as a shaky stand and a slant floor. Doing so may cause the machine to drop or fall down, causing an injury. Do not put the machine in a moist or dusty place.
-
Page 4: Table Of Contents
Introduction Thank you very much for purchasing the Paper Folder EP-42F. This machine enables users to achieve greater efficiency in clerical work by releasing them from paper-folding work that has manually been performed in the past. Please read this Operation Manual carefully before using this machine. -
Page 5: Information Before Use
1 Information Before Use (1) Precautions on Installation Caution Do not install it in an unstable place such as on a faltering bench or an inclined place. It may fall down or drop and cause an injury. Do not install it in a dusty place or a place of high humidity. It may cause a fire, or an electric shock. -
Page 6: 3) Part Name
(3) Part Name 16 17 18 Number Name Number Name Roller cover (10) Table 1 Left side cover (11) Control panel Paper feed roller (12) Paper feed table Paper guide (13) Table 2 Auxiliary feed table (14) Right side cover Paper ejection roller (15) Paper feed table lever... -
Page 7: 4) Operation Panel And Functions
(4) Operation Panel and Functions NONE START/STOP TEST 1000 EP-42F CLEAR/RESET Designation/Indication Function Test key Test folds two sheets without counting. Starts and stops the machine. Start/Stop key Clears counter indication resets error. Clear/Reset key Numerical key Inputs the desired number for subtraction counting . -
Page 8: How To Use
2 How to Use 1. Preparation (1) Setting Table 1 and 2 Fit (a) and (b) of Table 1 and (c) and (d) of Table 2 on the studs (a), (b), (c) and (d) at the left and right sides of the side plate. When setting Table 1, be sure to put the stopper plate in the center. -
Page 9: Operation Procedure
* Place the paper with its printed side down in case of fold-out. (5) Place the paper on the feed table so that it touches the paper lightly, and then tighten the paper setscrew. (6) Lower the paper feed table lever and set the paper. * If the paper does not come in contact with the paper feed roller, it may be fed improperly. -
Page 10: 3) Test Folding
(3) Test Folding Fold position adjustment knob Stopper plate Press the Test key to feed two sheets of paper. Check if the paper has been folded correctly by examining the second one of the two folded sheets. * When the fold position is not correct, refer to “Adjustment Paper Fold Position”. Caution Never put your hand in any of driving part such as a roller. -
Page 11: 6) To Start Folding
Turn the slant ejection adjustment knob to the right if the lower side of the folded paper slants to the right. Turn the knob to the left of the lower side slants to the left. * In other cases than single fold, place the folded paper with its face down on Table 1 and make slant ejection adjustment. -
Page 12: Maintenance
3 Maintenance (1) Before cleaning the machine, be sure to switch the power off and pull the power plug from the outlet. (2) When the unit is not in use, put its cover in place to prevent dust, paper chips, etc. to accumulating on the paper fold rollers. -
Page 13: Trouble Shooting
4 Trouble Shooting Trouble Possible Cause Measures Loosen the paper sufficiently or feed the Paper stuck just after it is printed paper after it is dry. Clean the paper feed separator using the Stains on the paper separator unit cleaner. The paper is not fed Clean the paper chips or ink on the paper Stains on the paper feed rubber roller. -
Page 14: Specifications
5 Machine Specifications Model EP-42F 91 x 128 mm (B7) to 297 x 432 mm (A3) or 3.5” x 5.0” to 11” x 17” Paper size B7 size is for SINGLE only. B6 size cannot be folded into GATE. Paper weight 45 –...