Table of Contents
Advertisement
Quick Links
Safety & Operating Instructions
CONVECTOR HEATER
CH-2000B TURBO
These instructions are for your safety. Please read through
them thoroughly before use and retain for future reference.
Parts Supplied
Ref Description
A
Main body
B
Feet
C
Screw for feet
Tools Required (not supplied)
Cross Head Screwdriver
Before You Start
Check the pack and make sure you have all of the parts listed
above.
This appliance is designed for use as a supplementary heat
source, it is not intended to be the main source of heat.
Illustration
1
Qty
1
2
4
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Fenix CH-2000B TURBO
- Page 1 Safety & Operating Instructions CONVECTOR HEATER CH-2000B TURBO These instructions are for your safety. Please read through them thoroughly before use and retain for future reference. Parts Supplied Ref Description Illustration Main body Feet Screw for feet Tools Required (not supplied)
- Page 2 PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY BEFORE USING THE APPLIANCE. • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
-
Page 3: Operating Instructions
• Place the appliance on a flat, stable, heat-resistant surface. Operating the product in any other position could cause a hazard. • There may be trace of odour during the first few minutes of initial use. This is normal and will quickly disappear. •... - Page 4 2. Insert the plug into a suitable wall outlet after turning the thermostat switch counter-clockwise to the minimum position and setting the Heater Switches and Fan Switch to “OFF”. The heater is suitable for operation on an electricity supply having the same voltage as that show on it’s rating label. 3.
- Page 5 Plug Replacement This appliance is supplied with a BS1363 3 pin plug fitted with a 13 Amp fuse. Should the fuse require replacement, it must be replaced with a fuse rated at 13 Amp and approved to BS1362. In the event the mains plug has to be removed/replaced for any reason, please note: The wires in the mains lead on this appliance are coloured in accordance with the following code:...
- Page 6 2. Clean the exterior surface of the product by wiping it with a soft, damp cloth. CAUTION: Allow the product to completely cool before handling or cleaning it. Ensure the product is in the “ 0 ” (OFF) position and the power cord is unplugged from the electrical outlet before cleaning the product.
Need help?
Do you have a question about the CH-2000B TURBO and is the answer not in the manual?
Questions and answers