Advertisement
1. UNPACKING
Unpack carefully. This equipment should be handled with care.
Check for the following items:
• Verify the unit model number.
• Verify that parts listed below have been included.
If an item appears to have been damaged in shipment, replace it properly in its carton and notify the shipper. If
any items are missing, notify your dealer or manufacture's Sales Representative or Customer Service. The shipping
carton is the safest container in which the unit may be transported. Save it for possible future use.
Hardware Kit
2 x ¼‐20 x 3/8" Hex Cross Recessed Head Screws
1 x ¼" Flat Washer
1 x ¼" Lock Washer
2. INSTALLATION
Tools required:
#2 Cross Recessed Screwdriver (Phillips)
1/8" Width Flat Blade Screwdriver
3/4" Open End Wrench
General Purpose Wire Stripper with Cutter
Optional: Adjustable Wrench
Materials required:
Outdoor Rated Cables for Power and Video
Cables must be round in shape with an outer jacket diameter of 0.170" minimum to 0.310" maximum.
1. Choose desired location for camera housing installation. Verify mounting structure and surface is capable of
supporting the camera and no obstacle or interference is present from existing installed devices or wiring.
2. Open housing by loosen the 2 Phillips head screws located on the
rear cap. Do not remove the lower two screws on the rear cap.
3. Holding the housing base securely, grasp front cap and cover,
pull forward sliding the cover off the base.
Grasp Here
4. Remove camera mounting bracket by loosen two retaining screws. Slide and lift bracket.
5. Attach camera and lens to bracket using ¼‐20 screw. The position of the camera can be adjusted by flipping
the bracket. The lens must not extend more than ¾" (0.750") beyond the front edge of the bracket.
6. Choose cable entry path for power and video. Using ¾" wrench, install cable gland fittings either in the rear
cap or mounting foot depending on the entry point chosen. Install plugs in the holes not used for cable entry.
Slide
Page 3
Loosen
These
Screws
Do Not
Remove
Advertisement
