Giant-Vac Classic Series Walk-Behind Leaf Blower Series 2 Assembly Instructions Operator's Manual

Giant-Vac Classic Series Walk-Behind Leaf Blower Series 2 Assembly Instructions Operator's Manual

Advertisement

A A S S S S E E M M B B L L Y Y I I N N S S T T R R U U C C T T I I O O N N S S
O O P P E E R R A A T T O O R R ' ' S S M M A A N N U U A A L L
P P A A R R T T S S L L I I S S T T
Actual product may differ slightly from product pictured above
3092642
Manual No. 7101096 (I.R. - 9/14/2006)
TP 100-5227-IR-BL-SNG
(Rev. 6/15/11)
Classic Series
Walk-Behind
Leaf Blower
Series 2
Models Covered:
s
LBC6152BV
7085921
(Part # 7085914)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Classic Series Walk-Behind Leaf Blower Series 2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Giant-Vac Classic Series Walk-Behind Leaf Blower Series 2

  • Page 1 A A S S S S E E M M B B L L Y Y I I N N S S T T R R U U C C T T I I O O N N S S O O P P E E R R A A T T O O R R ’...
  • Page 2: Model Number

    preliminaries Congratulations! You have just purchased one of the finest pieces of outdoor power equipment on the market today. If properly cared for, your new blower will provide years of dependable service. Please read and follow this instruction manual carefully in order to get the most out of your new equipment.
  • Page 3: Slope Operation

    safety rules regarding outdoor power equipment IMPORTANT! READ CAREFULLY THE FOLLOWING SAFETY RULES BEFORE ASSEMBLING OR OPERATING UNIT. TRAINING • Never operate with guards not securely in place. Be sure all safety features are attached, adjusted properly and func- • Read, understand, and follow all instructions in the manu- tioning properly.
  • Page 4: Maintenance And Storage

    safety rules regarding outdoor power equipment (cont.) CHILDREN • Shut off fuel while storing or transporting. Do not store fuel near flames or drain indoors. Tragic accidents can occur if the operator is not alert to the • Keep all hardware, especially impeller bolt, tight and keep presence of children.
  • Page 5: Front Wheel Assembly

    unit assembly Note: Please refer to Parts List for correct part identification and placement. FRONT WHEEL ASSEMBLY • Attach left and right caster brackets to caster wheel using 3/8-18 x 2-1/4 bolt and lock nut. Insert bolt through hole in bracket. Place caster wheel onto bolt. Place other caster bracket onto bolt.
  • Page 6: Starting The Engine

    unit operation STARTING THE ENGINE IMPORTANT NOTE: The procedures outlined within this section are general guidelines, and are in no way meant to replace or supercede engine manufacturer’s operating instructions. In order to obtain optimum performance from your engine, refer to your engine manual.
  • Page 7: Blower Operation

    unit operation (cont.) STARTING THE ENGINE (cont.) • Bracing unit with one hand on the upper handle and a RECOIL HANDLE foot on the right rear tire, firmly grasp recoil handle and pull briskly. You may have to pull several times before engine starts.
  • Page 8 unit operation (cont.) GENERAL RULES TO OBSERVE BEFORE AND DURING OPERATION: • Inspect your unit before each and every use. Check for worn, bent or broken components, loose fasteners, low or flat tires, etc., and repair or replace prior to operation. DO NOT OPERATE A MACHINE THAT IS WORN OR DAMAGED –...
  • Page 9 maintenance BEFORE MAKING ANY ADJUSTMENTS, STOP ENGINE AND DISCONNECT SPARK PLUG WIRE TO PREVENT INADVERTENT STARTING OF UNIT. GENERAL: • Follow implicitly the engine manufacturer’s recommendations for maintenance. • Always keep your machine clean – especially the engine. Check all adjustments periodically. Also, periodically check that all fasteners are secure.
  • Page 10: Troubleshooting

    maintenance (cont.) BEFORE MAKING ANY ADJUSTMENTS, STOP ENGINE AND DISCONNECT SPARK PLUG WIRE TO PREVENT INADVERTENT STARTING OF UNIT. TROUBLESHOOTING: • UNIT WILL NOT START: • Check fuel and oil levels. • Check to make sure choke is set when engine is cold, off when hot. •...
  • Page 11 decal identification 7075893 - EAR/EYE/BREATHING PROTECTION REQUIRED - LOCATED ON SIDE OF BLOWER HOUSING 7033874 - DANGER-FLYING MATERIAL - LOCATED ON SIDE OF BLOWER HOUSING 7013010 - DANGER-KEEP HANDS AND FEET AWAY - LOCATED ABOVE BLOWER DISCHARGE 7033686 - LEAF BLOWER WARNING - LOCATED ON SIDE OF BLOWER HOUSING...
  • Page 12 illustrated parts list...
  • Page 13 ASSEMBLY, Front Caster (includes items 19 thru 23) 7075760 DECAL, Logo - Snapper 1722551 DECAL, Logo - Simplicity 3078075 DECAL, Logo - Giant-Vac 7075893 DECAL, Ear/Eye/Breathing Protection Required 3023270 ASSEMBLY, Upper Handle & Grip - Narrow (p/n 33876 + grip) 7074422 GRIP, 1.0 x 21-1/2”...
  • Page 14 illustrated parts list (cont.) Item Part No. Description 7090391 WASHER, 5/16” Internal Tooth Lock 3071776 KNOB, Folding Handle 7046465 GUIDE, Rope 7090372 NUT, 1/4-20 Hex Center Lock, GR5 or B 3071800 THROTTLE CONTROL, B&S 7090505 SCREW, 1/4-20 x 2” Hex Head Cap, GR5 7076978 NUT, 1/4-20 Hex Nyloc 1717312...
  • Page 15 notes...
  • Page 16 A A S S S S E E M M B B L L Y Y I I N N S S T T R R U U C C T T I I O O N N S S O O P P E E R R A A T T O O R R ’...

Table of Contents