Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for AuviTran StageBox Kit
- Page 1 Installation Manual SatgeBox Kit V1.0...
-
Page 2: Precautions
WARNING Always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical shock, short-circuiting, damages, fire or other hazards. These precautions include, but are not limited to, the following: PRECAUTIONS Do not apply excessive pressure on connectors or To prevent electric shock, unplug the unit before any other part of the board. -
Page 3: Limitation Of Liability
All trademarks listed in this manual are the exclusive property of their respective owners. They are respected “as is” by AuviTran. Any use of these trademarks must receive prior approval of their respective owners. For any question, please contact the trademark’s owner directly. -
Page 4: Table Of Contents
PRECAUTIONS ........................2 LIMITATION OF LIABILITY ....................3 TRADEMARKS ........................3 COPYRIGHT ........................3 AUVITRAN WEBSITE / MORE INFORMATION ..............3 PACKAGE CONTAINS ....................... 3 WELCOME ! ........................ 5 OPENING THE BOX ....................6 FRONT PANEL DISASSEMBLY ................7 GPIO_WCLK CARD DISASSEMBLY ................ 8 GPIO_WCLK CARD REASSEMBLY ................. -
Page 5: Welcome
WELCOME ! Thank you for purchasing AuviTran’s Audio Toolbox AVBx3 Stagebox Kit. We hope you will enjoy using it. This kit will allow you to transform your Audio Toolbox from installation mode to Stagebox mode. You will find herewith the necessary instructions to use your product. Please read them carefully as misuse of this device might cause serious damage to you and your environment. -
Page 6: Opening The Box
Then, unscrew the two M3x6 countersunk screws that hold ears on each side of the box. Finally, unscrew the four M3x6 countersunk screws remaining on each side of the box. Remove the cover and keep all screws in a safe place. Installation Manual SatgeBox Kit V1.0 AuviTran 2011... -
Page 7: Front Panel Disassembly
It is possible that the “UI LED” card sticks slightly to the front panel. To take it off, just pull it gently. Keep the front panel, the “UI LED” card and the two screws in a safe place. Installation Manual SatgeBox Kit V1.0 AuviTran 2011... -
Page 8: Gpio_Wclk Card Disassembly
Unscrew the two M3x6 black screws from the front of the GPIO_WCLK card. Keep the two screws in a safe place. Remove the two spacers at both ends of the GPIO_WCLK's card. Keep the two spacers and two lock washers in a safe place. Installation Manual SatgeBox Kit V1.0 AuviTran 2011... -
Page 9: Gpio_Wclk Card Reassembly
Place the GPIO_WCLK card in the opposite opening to where it was originally. Screw the two spacers on the GPIO_WCLK card. Please ensure to put-back the lock washers. Screw the front panel with the two M3x6 black screws retrieved earlier. Installation Manual SatgeBox Kit V1.0 AuviTran 2011... -
Page 10: Connecting The Gpio_Wclk Card
Connecting the GPIO_WCLK card CONNECTING THE GPIO_WCLK CARD Connect the power cable supplied in the Stagebox Kit to the GPIO_WCLK card. Connect it to power supply (the tab prevent from a wrong insertion). Insert the power cable into the white cable guide located on the backplane. - Page 11 Put the power cable in the four cable clamps and tighten them so that the cable is pressed against the bottom of the box. Once the cable clamps tightened, cut their useless ends. Unfold the flat cable located on the backplane so that it does only pass once in the backplane guide. Installation Manual SatgeBox Kit V1.0 AuviTran 2011...
- Page 12 Connecting the GPIO_WCLK card Insert the 12cm long shrink tube supplied in the Stagebox kit on the flat cable. Connect the flat cable on the GPIO_WCLK card (blue side to the outside of the GPIO_WCLK card). Push the shrink tube so that it comes into contact with the connector.
- Page 13 Connecting the GPIO_WCLK card Slightly mark the folds so that the flat cable remains in place. Installation Manual SatgeBox Kit V1.0 AuviTran 2011...
-
Page 14: Dummy Front Panel Assembly
DUMMY FRONT PANEL ASSEMBLY Bring the dummy front panel (raw stainless panel) supplied with the Stagebox Kit and remove the protective film. Place the panel into the opening to the left of the GPIO_WCLK card, the notches down behind the plate. -
Page 15: Ui Led Card Assembly
UI LED CARD ASSEMBLY Retrieve the UI LED card and take the Stagebox Led front panel supplied in the Stagebox Kit. Screw the UI LED card on the back of the Stagebox Led front panel (the side where there are components in contact with the panel) with two M3x4 stainless screws previously removed and two lock washers supplied in the Stagebox Kit. - Page 16 UI LED Card Assembly Screw the Stagebox Led front panel + UI LED card to the box with two M3x6 black screws supplied in the Stagebox kit. Installation Manual SatgeBox Kit V1.0 AuviTran 2011...
-
Page 17: Connecting Ui Led Card
Insert the 4cm long shrink tube on the flat cable connected to the UI LED card. Slide the flat cable and the shrink tube in the metallic guide. Connect the flat cable on the backplane (blue side up). Slide the excess flat cable in the backplane guide so that it remains in place. Mark the folds slightly. Installation Manual SatgeBox Kit V1.0 AuviTran 2011... -
Page 18: Closing The Box
Use the two back holes of the ears for screwing it to the box in order to add a protection margin. Finally, screw the last four M3x6 countersunk screw on the side on the box, at the back. Installation Manual SatgeBox Kit V1.0 AuviTran 2011... -
Page 19: Lock Kit Installation
Take the lock kit and screw the GPIO_WCLK front panel on the GPIO_WCLK card with the two spacers, two washers and two nuts. Insert the locker through the two holes of the spacer, notch up. Installation Manual SatgeBox Kit V1.0 AuviTran 2011... -
Page 20: End Of The Operation
2 M4x10 black screws (if you decided to mount the lock kit) These parts are to be kept in a safe place throughout the life of the equipment for a possible return in installation mode of the device. Installation Manual SatgeBox Kit V1.0 AuviTran 2011...
Need help?
Do you have a question about the StageBox Kit and is the answer not in the manual?
Questions and answers