Page 9
29. To set built-in siren enable or disable when presspanic button on remote or panel keypad , please refer to adaptor 5.8. 30. Require user password before enter remote control. 31. Gsm alarm function:GSM alarm report to user and alarm report to CMS in CID.
Page 12
LINE TELL DC12V 500MA or higher(when without GSM module) DC 12V, 2A or higher (when the panel with GSM module) Here only introduce the zone #33,34,39,40.The other zone connect the same way.
Page 13
“Opration fauilure,zone trouble”. 0(zone open loop:zone #+0;zone close loop:zone #+5),under this status pls do not arm system.
Indication LED Arm: Normal on under away arm, blink under home arm. Disarm: Light on under disarm status, light off under disarm status. 12V : Light on when AC power connect, light off when AC power off. Alarm: Blink when alarming. Under panel stanby status press disarm button for 3s for emergency help.
Page 24
delete function [Arm] key with “back, exist” function. Under disarm status Only under disarm status,can enter system setting by pressing [*] for 3 seconds.
Page 26
Press 4-digit administtator password,press back key to exit,press # to save...
Page 27
When set CMS phone #,please press*,then enter the phone #. When only delete phone #,press * ,then press #. If set two CMS phone #,please set two user #.
Page 39
Example:Set timing arm/disarm,timing arm at 12:34, timing disarm at 22:54...
Page 41
If communication is normal Communication testing success -fully If communication failure Communication testing failure Exit system setting, Setting is saved Under communicat Setting is saved enter walking testin -ion testing press -g mode,press back return key to exit key to exit. If communication is normal Communication...