Summary of Contents for Seed SED-10R
-
Page 1: User Guide
Remote USER GUIDE for #SED-10R Customer Support: 866-377-4771 support@goecolife.com http://www.monomachines.com... - Page 2 http://www.monomachines.com http://www.monomachines.com...
-
Page 3: Table Of Contents
http://www.monomachines.com Table of Contents Product Specifications & Diagram......2 Caution ..............3 Technical Information...........4-5 Introduction .............6 Set Up Link...............7 Operation .............8-9 Mounting Holster ..........10 Frequetly Asked Questions (FAQs)....11-13 Limited Product & Connected Equipment Warranty..... 14-16 http://www.monomachines.com... -
Page 4: Product Specifications & Diagram
Product Specification SEED Remote & Holster ™ Power ON/ LINK Indicator Light Power ON Button Power OFF Button LINK to Remote Button Mountable Holster • Remote Range......65 ft/20 m • Remote Frequency ......433MHz • Batteries (not included).....Size AAA (2) •... -
Page 5: Caution
http://www.monomachines.com CAUTION • FOR INDOOR USE. DO NOT USE THIS PRODUCT NEAR WET AREAS SUCH AS SINKS AND NEAR AQUARIUMS. http://www.monomachines.com... -
Page 6: Technical Information
http://www.monomachines.com FCC Information • FCC ID: YF3MC-SED10R01 • This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. - Page 7 http://www.monomachines.com FCC Information (cont’d) the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Page 8: Introduction
OFF. PLEASE READ THROUGH THIS USER GUIDE CAREFULLY to ensure proper set up and operation of the SEED™ Remote. PLANNING • Make sure that the electrical devices you are planning to use with the SEED™... -
Page 9: Set Up Link
The indicator light will show a blue light for about a second. When both the flashing blue light on the SEED™ device and the blue light on the remote turns off, the remote is now linked to the SEED™ device. -
Page 10: Operation
Operation POWERING ON THE SEED™ DEVICE Before powering on the electrical devices connected to the SEED™, you must POWER ON the SEED™. To POWER ON the SEED™ with the SEED™ Remote, press the ON button on the remote. http://www.monomachines.com... - Page 11 Operation POWERING OFF THE SEED™ DEVICE There is only one way to manually power OFF a SEED™ device: • Press the OFF button for 3 seconds on the remote. NOTE: The SEED™ device is designed to automatically power OFF 5 minutes after all connected electrical devices have been turned off.
-
Page 12: Mounting Holster
Mounting the Holster MOUNTING THE SEED REMOTE HOLSTER On the back of the remote holster, expose the cover of the adhesive tape and attach vertically to either the wall or furniture. Place the remote holder in a location convenient for you to turn off your devices (i.e. -
Page 13: Frequetly Asked Questions (Faqs)
Frequently Asked Questions (FAQs) How does the SEED™ save energy? Electrical devices and appliances left plugged into outlets but turned OFF still draw electricity. This is known as “phantom load” or vampire energy consumption. Therefore, your electrical devices and appliances constantly... - Page 14 Frequently Asked Questions (FAQs) Can I link an additional remote to the same SEED™? Yes. You can link 4 SEED™ Remotes to a single SEED™. Can I link my remote to more than one SEED™? Yes. You can link your SEED™ remote to up to 99 SEED™...
- Page 15 Frequently Asked Questions (FAQs) What does “Certified CarbonFree®” mean? Your SEED™ is a carbon neutral product. It meets Carbonfund.org’s CarbonFree® Product Certification protocol which requires third-party life cycle assessment of the product’s carbon footprint, and carbon reductions in support of third-party validated renewable energy and reforestation projects.
-
Page 16: Limited Product & Connected Equipment Warranty
“Purchaser”) of the SEED™ Remote for period of one (1) year after the date of purchase, that the SEED™ Remote shall be free of defects in design, assembly, material, or workmanship for as long as the original Purchaser owns it,... - Page 17 (i.e. brownouts or sags), non-authorized program, or system equipment modification or alteration. (d) The SEED™ Remote is not used indoors only and in dry areas. 6. THIS LIMITED WARRANTY IS THE ONLY WRITTEN OR EXPRESS WARRANTY GIVEN BY THE MANUFACTURER.
- Page 18 4771. All claims must be filed within 15 days from the date of an Incident, if any, and must be accompanied by proof of purchase for the SEED™ Remote and must include the following information: 1. The SEED™ product model number 2.
- Page 19 http://www.monomachines.com http://www.monomachines.com...
- Page 20 http://www.monomachines.com Customer Support: 866-377-4771 support@goecolife.com Copyright © 200 INTEK America, Inc. Rancho Dominguez, CA 90220. ALL RIGHTS RESERVED. http://www.monomachines.com...
Need help?
Do you have a question about the SED-10R and is the answer not in the manual?
Questions and answers