Table of Contents
Advertisement
Quick Links
CLEANING THE FILTER. The timer is protected by a wire mesh lter that ensures long-lasting and trouble-free
operation. The lter should be inspected periodically and washed at the beginning of every season.
Simply remove the lter from the connector and rinse clean under running water.
1
1
For Tempo Select (cod.): 8486
FITTING/REPLACING THE BATTERIES. To t or replace the batteries, press the locking tab fully in to release the front part of
the timer, which can then be detached. Fit 2 new batteries in the holder, observing the correct polarity. As long as the batteries
are replaced within 2 minutes, the current settings will remain stored. Re t the front part of the timer to the back and press,
ensuring that the locking tab clicks into place. Important: always replace the batteries at the beginning of each season!
1
1
b
b
a
a
For Tempo Select (cod.): 8486
Tempo Select
Tempo Select
Pag. 1
2
2
2
2
b
b
NEW!
1,5V - AA - Alkaline
3
3
Washing at start
of season
3
3
User manual
User manual
click!
Advertisement
Table of Contents
Related Manuals for claber Tempo Select
Summary of Contents for claber Tempo Select
- Page 1 Washing at start of season For Tempo Select (cod.): 8486 FITTING/REPLACING THE BATTERIES. To t or replace the batteries, press the locking tab fully in to release the front part of the timer, which can then be detached. Fit 2 new batteries in the holder, observing the correct polarity. As long as the batteries are replaced within 2 minutes, the current settings will remain stored.
- Page 2 3/4” click! For Tempo Select (cod.): 8486 SELECTION OF WATERING PROGRAMME. Press any button once to light up the display. Press the “M” button once or repeatedly (e.g. 5 times) until the required value is displayed in eld “D” (e.g. 5 min ). Set the watering frequency (interval of time between successive watering cycles) by pressing the “F”...
- Page 3 Time until next watering 10 sec. For Tempo Select (cod.): 8486 Delayed start. Within 10 seconds of selecting the programme, press the “START” button repeatedly until display eld “C” shows the delay, between 1 and 23 hours, before the start of the automatic watering cycle (e.g. 6 hours). Release the button, and the number of hours will blink 3 times, after which the programme begins the countdown to the auto- matic start of the watering cycle, shown in display eld “C”...
- Page 4 . e v e r y 7 days 3 sec. For Tempo Select (cod.): 8486 RESET. The factory settings of the timer can be restored at any given moment by pressing the MANUAL and START buttons simultaneously and holding them for at least 10 seconds.
- Page 5 Wired Rain Sensor. Fit the connector of the sensor lead. Check that the two-core cable enters the timer by way of the slot provided in the rear of the housing. cod. 90915 OK!!! For Tempo Select (cod.): 8486 RF Rain Sensor. Install the RF Rain Sensor Interface, routing the wire antenna through the relative clips. cod. 90831 cod. 8480...
- Page 6 This will ensure that the timer remains as good as new for many springs and summers to come! OFF! For Tempo Select (cod.): 8486 For more information and further details, please consult the instruction manual supplied with the product.
Need help?
Do you have a question about the Tempo Select and is the answer not in the manual?
Questions and answers