Assembling The Blower - Toro Ultra 225 Operator's Manual

Important: Safety and instruction decals are located near areas of potential danger. Replace damaged or lost
decals.
SAVE THESE INSTRUCTIONS
Assembly

Assembling the Blower

1.
Important: You must install the blower tube before installing the inlet cover because the inlet cover hooks onto
the blower tube. The blower will not run unless the bottom inlet cover is locked in place.
Converting from Blower to
Vacuum
1.
Caution
The impeller rotates for a few seconds after you
turn off the blower and can cut or injure fingers.
Do not remove the bottom inlet cover when the
motor is running or when the unit is plugged into
a power outlet.
3
2.
2.
m–5112
3.
Note: Ensure that you line up the arrows.
3325-832
3.
m–5113
m–5122