Subscribe to Our Youtube Channel
Summary of Contents for MobilePower POWER 400
- Page 1 Model No. 2001 POWER 400 Instruction Manual MobilePower, LLC. Bluffton, SC 29910 www. Mobilepower-us.com Office: (800) 708 - 8550 support@mobilepower-us.com customerservice@mobilepower-us.com...
-
Page 2: Important Information
Model No. 2001 POWER 400 6 in 1 POWER SUPPLY with 400W inverter Polarity Indicator LED LED Work light ON/OFF Switch Air Compressor ON/OFF Switch Battery Charge Status Dial Gauge Double Injection Rubberized Handle 12 VDC Socket with Air Pressure Gauge... - Page 3 Prevent water to get into Power 400 housing. Water will damage the internal electronics board. This unit has a built-in lead acid battery. Although Power 400 arrives partially charged from the factory, it MUST be fully charged before the first use.
- Page 4 3. Connect the 12 Volt DC Charger Plug into the vehicle cigarette lighter or 12 Volt accessory port. 4. Fully charge the Power 400 internal battery for 8 hours while the vehicle engine is running. 5. Unplug the DC charger from the vehicle cigarette lighter or 12 Volt accessory port first and then...
- Page 5 TO INFLATE TIRES: 1. Open the Compressor Air Hose Compartment access door at the left side of the Power 400 and pull out the air hose. Make sure that the Nozzle Locking Lever is in the UP position.
- Page 6 Connect the Booster Cable 12 Volt DC plug with LED power indicator into the vehicle cigarette light- er or 12Volt DC socket. Connect the other end of the Booster Cable into the Power 400 unit 12 Volt DC port. Make certain a good connection is made.
- Page 7 NOTE: If the vehicle fails to start, reconnect the dual 12 Volt DC plug Booster Cable to the vehicle and the Power 400 12 Volt DC port. Allow an additional 20 minutes for boost charge before attempting to restart vehicle again.
- Page 8 Model No. 2001 4. Determine whether your vehicle designed with a negative or positive grounded system: In the Negative Ground System, the negative battery terminal is grounded to chassis of the vehicle. Most vehicles use this type of system. Positive Grounded battery terminal is grounded to chassis or any other part of the vehicle.
- Page 9 Protection RED LED is illuminated. Disconnect both booster clamps and reconnect the Booster Clamps to the proper polarity. Allow the Power 400 to stay connected to the vehicle battery for a longer period of time. Wait 6 to 8 minutes before attempting to start the vehicle again.
-
Page 10: Specifications
Lead Acid rechargeable battery pack warranted for a period of one year. If the product is determined by MobilePower, LLC. to be defective in material and workmanship during the warranty period, MobilePower, LLC. - Page 11 Model No. 2001 NOTES MobilePower, LLC. Bluffton, SC 29910 www. Mobilepower-us.com Office: (800) 708 - 8550 support@mobilepower-us.com customerservice@mobilepower-us.com...
- Page 12 Model No. 2001 MobilePower, LLC. Bluffton, SC 29910 www. Mobilepower-us.com Office: (800) 708 - 8550 support@mobilepower-us.com customerservice@mobilepower-us.com Made in China...
Need help?
Do you have a question about the POWER 400 and is the answer not in the manual?
Questions and answers
I purchased a Power 200 wayback when, Model ACD032, I need the power cords to charge this unit.Please advise.
Need to replace battery