Figure 2-2 Rack Mounting Plate In Use; Figure 2-3 Mux Card Bulkhead With Self Test Indicator - HP e3000 Installation And User Manual

2. Attach the plate to the rack using appropriately-sized
3. Place one interchange panel against the back plane of the mounting
4. To mount another interchange panel to this same plate, repeat the
Figure 2-2 Rack Mounting Plate In Use
Connect the MUX to (one of) the Interchange Panel(s)
Before connecting the MUX card cable to the interchange panel, be sure
CAUTION
that the power to the computer is off. Otherwise, serious equipment
damage may occur.
1. Connect one end of the supplied cable to the connector on the MUX
2. Apply power and reboot the computer.
3. After power is applied, check the Self Test LED indicator at the
Figure 2-3 MUX Card Bulkhead with Self Test Indicator
Chapter 2
machine-metal screws for your rack.
plate. Mount it to the plate, using the M3x10 Torx screws provided
with the plate.
preceding step. Note that you can position the plate in a different
direction from the first one, as shown in Figure 2-2.
card and the other end to the interchange panel.
bulkhead of the MUX card, refer to Figure 2-3.
Hardware Installation
Installing the 8-Port PCI ACC Multiplexer
Z7322A
V.35 INTERCHANGE PANEL
J7 J6 J5 J4
J3 J2 J1 J0
P2
P1
23