Banks - Korg Kaptivator KTV1 Owner's Manual

3. Banks

Eight clips are saved together as a "bank." You can save one hundred banks of clips.
(Maximum 800 clips of 8 seconds; Maximum total video recording time is approximately 1
hour 46 minutes)
Selecting a bank
You can select a bank and assign it to either group of clip pads, Group A (the upper eight clip
pads) or Group B (the lower eight clip pads). You can select a new bank while a clip is play-
ing and you can select the same bank for both groups.
Assigning a bank to a clip pad group
1 Press the BANK key. When the BANK key is blinking green, you can assign a new bank to
Group A. When the BANK key is flashing orange, you can assign a new bank to Group B.
2 Use the VALUE knob to change the "BANK No." indication shown in the VALUE display
and assign that bank to the selected group
Copying a bank
You can copy the currently selected bank by setting one group as the copy-source, and the
other as the copy-destination
Copying an entire bank of clips
1 Hold down the EDIT key and press the BANK key; the EDIT key and BANK key will blink,
and you'll be ready to copy clips.
2 Use the VALUE knob to select the copy-source bank, and press any clip pad twice in the
copy-source bank. The eight copy-source clips shown in MONITOR 2 will be indicated by
a red frame. The BANK key will now indicate the other group
NOTE You can't copy if you're unable to select a vacant bank. If there is no available copy-destination,
you'll need to erase clips (☞p.23) to create a vacant bank.
3 Use the VALUE knob to select the group for the copy-destination bank. If the copy-destina-
tion bank is empty, the eight clips will be indicated by a blue frame.
4 Press the YES/WRITE button twice to copy the bank.
Press the NO/ESC key once to un-select the copy destination (blue frame).
Press the No/ESC key a second time to un-select the copy-source (red frame).
To cancel the entire Bank Copy operation, be sure the copy destination and copy-source have
been un-selected, then press the NO/ESC key twice.
25