Page 2
Safety Notice Please read this entire Operation and Warranty Manual BEFORE operating your new Thermal Wave Electronic Infrared Zone Heater. Save These Instructions TABLE OF CONTENTS Safety Instructions Heater Operations & Placement Troubleshooting Warranty & Warranty Card IMPORTANT INSTRUCTIONS READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE...
Page 3
5) Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair. 6) Do not use outdoors. 7) This heater is not intended for use in bathrooms, laundry areas and similar indoor locations.
FIREPLACE OPERATION Plug your Infrared fireplace heater power cord into a 120V, 15 amp or 20 amp three bladed outlet. To Turn the Heater On: Press the Power button (1) on the control panel or on the remote control. To Set the Temperature: Press...
FIREPLACE PLACEMENT Our Infrared Fireplace heater is a very safe and effective room heater. It produces safe, clean and economical heat by utilizing quartz infrared heating elements and multiple copper heat exchangers. The heating process of the Infrared Fireplace heater is similar to the way the sun warms the earth.
TROUBLESHOOTING If your heater shuts off unexpectedly: 1. Be sure the power cord is plugged into a working outlet. 2. Check for any obstructions. If you find one, turn the heating unit OFF and unplug it. Wait at least 10 minutes to allow the heating unit to cool com- pletely before removing any obstruction.
Page 7
WARRANTY CLAIM PROCEDURE: Any product that proves to be defective within the warranty period must be delivered to the nearest Thermal Wave Warranty Service Center or to the address below. All transportation charges are the responsibility of the consumer.
Need help?
Do you have a question about the INFRARED FIREPLACE and is the answer not in the manual?
Questions and answers