Metria IH1 User Manual

Chapter 1: About Metria IH1
Device Description
The Metria IH1 enables the collection and reporting of up to
seven days of daily lifestyle data used for achieving health and
wellness goals. Metria IH1 is validated for person that is 18
years of age or older.
HEALTH DISCLAIMER
WARNING: Metria IH1 by Vancive is not a medical device.
Metria IH1 and its associated applications should not be
used to diagnose, treat, or prevent any disease or medical
condition. Always seek the advice of a qualified medical
professional before making any changes to your lifestyle such
as exercise, sleep or nutrition, as doing so may cause severe
harm or death.
Chapter 2: Metria IH1 Basics
Metria IH1 at a glance
A
C B
A. Power button B. LED light C. Micro-USB port
Chapter 3: Wearing Metria IH1
Wear your Metria IH1 on the back of the upper left arm,
triceps. To work properly, the Metria logo on the device must
read upright and the stainless steel sensors on the underside
of the device need to be in contact with your skin. Metria IH1
is designed for use in a HORIZONTAL position across the left
upper arm.
1) Prepare the skin
TIP: For optimal adhesion, the best
time to apply the Metria IH1 is just
before you go to bed.
a) Do not use sun screen, lotion,
moisturizer, or oils in the intended
wear area for 24 hours prior to
applying Metria IH1.
b) Locate the back of your upper
left arm where you will apply the
Metria IH1, as illustrated.
c) If applicable, excess hair where
Metria IH1 will be applied needs
to be removed with hair clippers.
It is not recommended to shave
the arm area with a razor, as this
can promote skin irritation.
d) Thoroughly clean the area on the
back of your upper left arm with
the provided alcohol wipe.
e) Allow the skin to dry for 2 minutes.
2) Activate the Metria IH1
Metria
a) Turn on the Metria IH1 indoors, as the LED light may not
be visible in the direct sunlight.
b) Activate the Metria IH1 by holding the top and bottom
of the raised center with your finger for at least 3
seconds until a green LED light turns on, as illustrated.
Avoid using fingernail as it may puncture the cover.
c) The green light will turn off after 2 seconds.
d) Your Metria IH1 is turned on and collecting data.
NOTE: Metria IH1 does not have a power off button. It needs
to be activated before the expiration date for complete
functionality. You can check its essential performance of the
product at any time by pressing down the top of the raised
center. The LED light will flash if the product is activated.
3) Apply the Metria IH1 to the arm
a) Flip the Metria IH1 over
b) Carefully remove the LARGER of the two backing strips.
Avoid touching the sensors and the sticky adhesive on
the back of the product.
NOTE: Should
it be difficult to
reach to the back
of the left arm,
triceps, ask for
assistance from
Metria someone else to
apply the device.
c) While looking in a mirror to ensure correct alignment,
orient the product on your arm. Metria IH1 should be
worn in the HORIZONTAL position with the Metria logo
oriented correctly.
d) Gently press the product on to the skin over the
uncovered adhesive, while pulling the second backing
strip away from underneath. With your fingers, smooth
the edges of the product on to the skin to secure it in
place.
e) Once the entire adhesive area is secured to the skin,
apply firm pressure for 15 seconds to all adhesive
surface areas of the device. Please note that Metria IH1
must not be re-positioned once stuck to the skin.
f) To ensure proper adhesion, wait 3 hours after initial
application before exercising or showering.
MTR-LBL-000086-D